ENDURO® autoSteady 37
Ref: AS201AFL/BFL-UM-TKI-0419-Rev. A
than the two back corner steadies (Fig. 7B and Fig. 7D) draw back completely
When the AUTO function process is finished, there will be a beep.
After operation, deactivate the autoSteady system by moving the slide switch (Fig. 8A) to “Off”-O on the
remote handset. The LED (Fig. 8H) on the remote handset will turn off. Store the remote handset in a safe
place (out of reach of children or other unauthorized people).
Turn off the battery power isolation switch.
Before you start driving always make sure that the four steady feet are fully lifted! Please
check the one by one!
Individually adjustment:
First choose the “Up button in individual mode” (Fig. 8B) for draw back or “Down button in individual
mode” (Fig. 8C) for lower by press the button.
Press the single corner steady function button (Fig. 8D,E,F,G) to lower or draw back individually. The corner
steady will move if the single corner steady function button is kept pressed. It will stop if the button is released.
In addition, two corner steady function buttons (Fig. 8D,E,F,G) can be pressed to lower or draw back two corner
steady at the same time. For example both front or rear corner steady or both left or right corner steady.
If the press force (from ground and chassis) on corner steady is too big, the motor will stop, even if the single
corner steady function button is kept pressed.
The single corner steady function is used to adjust the height of single corner steady a little.
Do not try to jack the caravan by this function, this could completely damage your caravan
chassis or floor.
Different caravan chassis/ floor have different situation for jack-up force. Using the single
corner steady function button have the possibility to completely damage your caravan
chassis/ floor. The stop setup on the single corner steady function is used to protect the
motor and control unit, it cannot protect your caravan chassis/ floor all the time(this due to
the various caravan models).
After operation, deactivate the autoSteady system by moving the slide switch (Fig. 8A) to “Off”-O on the
remote handset. The LED (Fig. 8H) on the remote handset will turn off. Store the remote handset in a safe
place (out of reach of children or other unauthorized people).
Turn off the battery power isolation switch.
Before you start driving always make sure that the four steady feet are fully lifted! Please
check the one by one!
If you forget to draw back the corner steady after using, the emergency draw back function will draw back the
corner steadies automatically when you connect the 13-pin (or 7-pin) plug to the towing vehicle’s socket.
The emergency draw back function is only for emergency situations if you forget to draw
back the corner steady. Never use this function as a normal draw back method.
The emergency draw back function still works even if the battery voltage is too low. It will
not function if the battery isolation switch is turned off.
