GB-12
Component :Set the video output to interlacing component output.
RGB: Set the video output to SCART output. If you select SCART connection, you
should set up the play mode as RGB state, then it will output normally.
P-Scan: Set the video output to progressive component output
HD: Set the video output to high definition output
Note1: When the player is connected to a TV set of progressive scanning though YPbPr, select P-SCAN.
When it is connected to a common TV set, select Component.
If TV screen has no output after selecting P-SCAN, you can press V-MODE button to
switch the state, it will output normally.
If you select SCART connection, you should set up the play mode as RGB state, then it will output
normally.
If you select HDMI connection, you should set up the play mode as HD state, then it will output
normally.
Note2: Set video output type to “Component”, “RGB” or “P-Scan”.
HD resolution menu should be disabled.
HDMI should stop working
HD JPEG mode menu should be disabled.
Note3:Set video output type to HD.
HD resolution menu should be enabled and set to “Auto” responding to this action.
“HD/Res.” key is valid to switch HD resolution only at this case.
HDMI module can work only at this case.
No CVBS at HD resolution
No OSD and sub-picture at HD-JPEG mode
9.2.5 HD Resolution
Used to set the resolution of HDMI image output. In this option, you can select different
HDMI image resolution.
Note: If TV screen has no output after selecting HD Resolution, you can press SETUP once then press
V-MODE button or restart the player and press V-MODE button to switch the state, it will output normally.
9.3 Audio setup
Select Audio in the setup menu, and display the Audio submenu.
9.3.1 Bass Management
To enable or disable the Bass Management during operation of the player.
On = Enable the Bass Management.
Off = Disable the Bass Management.
9.3.2 Front Speakers
To adjust the front speakers output to work in harmony with the audio equipment (e.g. receiver, speakers)
connected to the player.
When Bass Management is On, the following options are available:
Large : Support signal frequency lower than 200Hz
Small : Support signal frequency higher than 200Hz
If the connected speaker supports signal lower than 200Hz, it is best to select Large: If not, you shall select
Small.
9.3.3 Center Speaker
Selection of Large or Small is same with that of front speaker. The speaker will have no signal output if set to
None.
Notes:
If the Subwoofer is On, Center is set to None or Small, and bass from the center channel
is redirected to the subwoofer. If the content contains a discrete subwoofer channel, it is
also sent to the subwoofer. If the Subwoofer is Off, Center is set to None or Small, and
bass from the center channel is redirected to the left and right channels. If the content
contains a discrete subwoofer channel, it is discarded.
