741425
33
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
33/52 HPA800
Two types of sound can be selected using DIP A3.
If the system status and alarm memory functions are not used, it is possible, although not recommended,
to deactivate the limit of 8 alarms in 24 hours by connecting the TC input to the ALL input. In this case,
the alarm cycle ends with a continuous low power tone of 3 seconds.
3.7 ALARM MEMORY SIGNALLING
If enabled via DIP B1, the siren can display the alarm memory condition, distinguishing the origin of the alarm,
as shown in the following table:
The alarm memory light signal is continuous regardless of the system status (on or off).
The alarm memory is deleted the next time the system is switched on or off.
To enable the alarm memory display, the DIP B1 must be set to OFF.
Alarm memory signallings have priority over the system status signalling.
3.8 BATTERY/POWER SUPPLY FAULT
The internal battery charge is managed by the siren board. Under normal charging conditions, the siren board is
checked and limited in current to prevent excessive absorption from compromising the external power supply. In
case of prolonged external power supply voltage failure, the battery voltage may drop below a value such to
cause instability in the electronics and possible deterioration of the battery; in this case, the board inhibits all
siren functions, indicating the status.
When the power supply voltage returns, the battery is subjected to impulsive charging with reduced duty-cycle:
this helps to regenerate the battery if it is undercharged limits stress on the charge limiter. The siren functions
are restored when the normal operating voltage is reached.
WARNING ! In case of a faulty or discharged battery, if the control panel is not able to supply sufficient
current to sound the alarm, the siren restarts and does not return to service until the alarm signal returns
to rest. In this case, if the control panel is equipped with a dedicated power supply for the sirens with a
current limiter, a fault signal can be generated due to an overload of the output.
4 central LEDs
(high brightness)
Stored event
2 flashes every 2 seconds
system alarm memory (siren alarm input)
3 flashes every 2 seconds
alarm memory tamper siren (internal microswitch)
4 flashes every 2 seconds
alarm memory anti-foam siren (internal active anti-foam protection)
On 4 central LEDs
(high-intensity)
Siren condition
1 flash every 5 seconds
siren temporarily inhibited due to battery/power supply failure
33

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elkron HPA800 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elkron HPA800 in de taal/talen: Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 3,52 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info