39
Automatic operation (sensor), connection with SNAP
®
and Elica hob
Attention! We recommend "Adjusting the parameters for
automatic Operation" (see relative paragraph) before using
the automatic operation and connecting the hood to SNAP
®
and to the Elica hob.
Automatic operation (sensor)
The hood will switch on at an adequate speed depending on
the cooking fumes detected by the hood sensor.
To activate this function:
Press keys T1 and T2 simultaneously. LED L1 will light up
showing several colours, whereas LED L2 will turn white.
Automatic operation of the hood with SNAP
®
Note: SNAP
®
is an auxiliary suction unit capable of operating
together with the hood. For further information, refer to the
manual supplied with SNAP
®
To activate this function:
Press keys T1 and T2 simultaneously. LED L1 will light up
showing several colours, whereas LED L2 will turn orange.
Automatic operation of the hood with the Elica hob
The behaviour of the hood depends on the use of the Elica
hob.
To activate this function:
Press keys T1 and T2 simultaneously. LED L1 will light up
showing several colours, whereas LED L2 will turn blue.
Automatic operation of the hood with SNAP
®
and Elica
hob
To activate this function:
Press keys T1 and T2 simultaneously. LED L1 will light up
showing several colours, whereas LED L2 will turn orange.
Adjusting the parameters for automatic operation.
Note: All the calibration, selection, adjustment, and
logical connection operations described below are
possible with hood OFF and involve:
• Hood calibration (automatic or manual).
• Hob selection (gas - induction or electrical)
• Logical connection between hood and hob (if in
possession of an Elica hob)
• Logical connection between hood and SNAP
®
(if in
possession of SNAP
®
).
Sensor calibration
Note: Calibration lasts about 5 minutes. LEDs L1 and L2
turn white and flash.
Calibration is required to allow the hood sensor to run
properly. Calibration can be:
Automatic:
every time the hood is reconnected to the mains (e.g.
upon first installation or after a blackout).
Manual:
To be carried out if unsatisfactory automatic operation is
detected and under normal kitchen conditions.
Press and hold key T1..
Hob selection (gas - induction or electrical)
Simultaneously press keys T1 and T2 until you hear a
beep. Release the keys and press solely T2 (within about
5 seconds) to access the hob selection mode..
Press T2 again to choose the required hob according to
the layout below:
Orange LED 2 Gas hob
Blue LED 2: Induction hob
White LED 2: electrical hob
The selected key remains on to indicate the selection.
After 10 seconds, the key flashes temporarily to indicate
that the selection made has been recorded.
Logical connection between hood and hob (if in
possession of an Elica hob).
a. Connect the hood and Elica hob simultaneously.
b. the hood emits two intermittent beeps to indicate
that it is ready to receive the connection signal from
the Elica hob.
c. the attempts to connect to the Elica hob last 5
minutes. Within this period, the hood emits 3
consecutive beeps to indicate that the Elica hob has
been connected successfully.
d. Check the connection with the Elica hob (see
paragraph "Automatic operation of the hood with
the hob").
In the event the logical connection between the
hood and Elica hob has failed, proceed as
follows:
Disconnect and reconnect the hood to the mains at
least 5 times within 30 seconds.
Repeat operations a-b-c-d described above
Logical connection between hood and SNAP
®
(if in
the possession of SNAP
®
).
The connection between hood and SNAP
®
is
automatic. No setting is required.
