applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Description of parts (Fig. 1)
A: Air inlet
B: Cover
C: Air filter
D: Housing
E: Emergency switch for automatic operation
F: Air outlet
G: Slat
H: Power cable
I: Infrared remote control
J: Condensation water hose
K: Refrigerant line
L: Heating
M: Cooling/dehumidifying
N: Operating display
O: Air inlet
P: Air outlet grille
Q: Air outlet
6. Setting up the remote control (Fig. 2)
Insert batteries
1. Open the battery compartment cover.
2. Insert two new batteries. Be sure to observe the
correct polarity (+/-) of the batteries.
3. Close the battery compartment cover.
Notes
앬 The radio signal has a range of approx. 8 m.
앬 Use two alkali batteries, type R03 AAA (1.5 V).
앬 Always replace both batteries at once when you
can no longer see the LCD display.
앬 Never use a combination of new and used
batteries.
앬 Never use a battery type other than the specified
one.
앬 If the remote control is not used for a lengthy
period of time, remove the batteries to prevent
them leaking.
앬 The service life of the batteries if the remote
control is used normally is approximately 12
months.
앬 Dispose of spent batteries properly.
Notes
Keep the remote control approximately 1 m from
television sets or other electrical appliances. Direct
sunlight may considerably reduce the range of the
remote control.
Objects between the remote control and the IR
receiver which can impede reception of the signal
must be avoided. Handle the remote control with
care. Do not drop it, keep it away from heat and
moisture so as not to damage the remote control.
7. Functional description of the remote
control
Key assignment (Fig. 3)
1 “Mode” (operating mode) key
2 “Fan” (fan speed) key
3 “Sleep” (sleep function) key
4 “Swing” (automatic, horizontal slat adjustment)
key
5 “+ °C” (temperature increase) key
6 “- °C” (temperature decrease) key
7 “T-ON” (device ON timer) key
8 “T-OFF” (device OFF timer) key
9 “ON-OFF” (device ON/OFF) key
“AIR” and “LIGHT” keys are not assigned
Display (Fig. 4)
1 “Fan speed” display
2 “Mode” display
3 “Temperature” display
4 “Sleep mode” display
5 “Slat adjustment” display
6 “Timer” display
Remote control brief description
(Fig. 5-6)
1 “Mode” (operating mode) key
This key is used to select one of the available
operating modes. The operating mode changes in
the following sequence per key press:
Automatic -> Cooling -> Dehumidifying -> Fan ->
Heating
2 “Swing” (automatic, horizontal slat adjustment)
key
Press this key once for electric, horizontal slat
adjustment. The air flow is adjusted
upwards/downwards.
Press the key twice to lock the slats in their current
position.
3 “+ °C” (temperature increase) and “- °C”
(temperature decrease) keys
Press the “+ °C” key once to increase the set
temperature by 1°C. Press the “-°C” key once to
12
GB
