EN 14
Assembly
1. Plug the three support legs (5) into the recesses on the bottom of the motor unit (7).
2. Screw the top and bottom rod parts (9, 10) together.
3. Place the drip guard (8) onto the motor unit (7).
4. Screw the bottom rod part (9) tightly into the thread on the top of the motor unit (7).
5. Pull the drying frame (2) over the top rod part (10) and push it down as far as it will go.
6. Place the drying bars (1) onto the top rod part (10) and push each one down as far
as it will go.
7. Pull the cover over the whole frame.
The device is disassembled in the reverse order.
Use
ATTENTION!
! Only place the device on a stable, fl at, heat-resistant and moisture-resistant surface.
■ Caution! Hot surface! The motor unit will become very hot during use. You should
therefore not touch it during or shortly after use.
■ It is essential that you follow the care labels for the textiles to be dried!
■ Do not hang any wood hangers in the device. We recommend the use of plastic
hangers.
■ Never cover up the ventilation slots and do not insert any objects into them. Also do
not hang the clothes which are to be dried over the ventilation slots.
The device is intended primarily for machine-spun laundry! If hand-washed or
non-machine-spun laundry is hung up, it is essential that you place a suitable
vessel and / or a towel underneath it to collect the water which drips down. Do not
use the device on moisture-sensitive fl oors such as laminate, fi tted carpets
or parquet fl ooring!
1. Open the zip fasteners on the cover if necessary and hang laundry on the drying
bars (1) and the drying frame (2). Attention! The laundry must not extend down any
lower than the drip guard of the motor unit (8)!
2. Close the zip fasteners on the cover.
3. Insert the mains plug into an easily accessible socket.
4. Turn the controller (4) clockwise and set it to the length of time you want.
To permanently switch on the device, turn the controller (4) anticlockwise and
move it to the ON position. Attention! In this setting, the device must be switched
off manually by turning the controller (4) to the OFF position.
5. When the set time elapses, the device switches off automatically. The drying process
can also be interrupted at any time by turning the controller (4) to the OFF position.
6. Open the zip fasteners on the cover (4) and remove the dry laundry.
7. Pull the mains plug out of the plug socket and allow the device to cool down completely
.
