761230
14
Verklein
Vergroot
Pagina terug
1/64
Pagina verder
14
Use caution when removing the casing.
The casing may have sharp edges/
corners which may cut or cause harm.
1. Place the main body on a cloth to
avoid marking its surface.
2. Remove the (2) security screws from
the main body, using the service tool
provided. Store safely.
3. Lift the backplate out of the main
body.
4. If cable entry is to be from the rear,
remove the rubber cable grommet
from the rear cable entry hole. Store
safely.
2
1
3.2
Positioning.Unpacking.Contents.
EN
Side cable entry.
IMPORTANT
Cable entry can be either from the
left or the right. Decide which before
you start.
The unit is designed to have only one
side cable entry point.
NOTE: If the side entry option is
chosen, a fifth hole will need to be
drilled in the wall.
Make sure you work on the correct
side for the installation. The break-
out on the main body must match up
with the bracket on the backplate.
Once the break-out panel on the
main body has been removed there
is no option to swap sides.
CAUTION
Before installation decide if the cable
entry is to be from (3.1) the rear or
(3.2) the side. Follow the relevant
instructions.
NOTE
This product is not recommended for
mounting onto porous wall surfaces
(e.g. plaster) without a back panel,
to avoid discolouring or damage to
unprotected walls. (A back panel for this
product is available from Dyson.)
Recommended height measurements are
from the floor.
1300mm adult male.
1265mm adult female.
928mm children 58 years old.
1028mm children 8–11 years old.
1108mm children 11–14 years old.
1050mm wheelchair user.
211m m
Side cable
entry
Backplate
Main body
Side cable
entry
Rear cable
entry
CAUTION: Do not use the backplate
as a guide when drilling. Ensure no
pipe work (gas, water, air) or electrical
cables, wires or ductwork are located
directly behind the drilling/mounting
area.
NOTE: If the side entry option is chosen,
a fifth hole will need to be drilled in the
wall. See step 3.2.
1. Select the appropriate height.
Recommended heights are shown,
but may need to be adjusted for
each individual installation.
2. Minimum clearances are: above,
30mm; sides, 220mm. There should
be no obstruction between the unit
and the floor.
3. Measure the location on the wall. If
cable entry is to be from the rear, the
1. Ensure you work only on the side of
the fascia that you have chosen for
the cable entry point.
2. Use pliers to carefully nip out only
one pre-marked break-out panel in
the correct side of the main body.
Align to one of the edges and break
off an initial part of the panel.
3. Align to the other edge and break
off an initial part of the panel.
4. Break off the whole part from the
centre.
5. Clean up any excess plastic.
6. Drill holes.
CAUTION: Do not use the backplate
as a guide when drilling. Ensure no
pipe work (gas, water, air) or electrical
cables, wires or ductwork are located
directly behind the drilling/mounting
area.
7. Pull the electricity supply cable
through the side bracket and side
bracket seal as shown. Ensure
that cable is long enough to route
correctly through the backplate to
the terminal block. (Note: cable
length will be different for left and
right side entries.)
NOTE: Ensure suitable cable gland/
conduit connector is used (not
provided) for the installation.
Fixing the backplate to the wall.
Fit the main unit securely to the wall
using the appropriate fixings for
the wall type and weight of the unit.
Slide the side bracket into the recess
between the wall and the backplate.
Screw to the wall and secure with the
appropriate fitting.
Do not use counter-sunk screws.
Main unit x 1
Side bracket and
seal assembly
Service tool x 1
RightLeft ● Primary fixing locations (x4).
Do not use countersunk screws.
5th hole for side entry
6mm
REAR VIEW REAR VIEW
24mm
to top of
fascia
14

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Dyson AB12 - Airblade V bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Dyson AB12 - Airblade V in de taal/talen: Alle talen als bijlage per email.

De handleiding is 19,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Dyson AB12 - Airblade V

Dyson AB12 - Airblade V Aanvulling / aanpassing - English - 1 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info