108
Advanced Setup – Part 1
Volume Limit:
Set the upper limit for the volume for the different
zones.
•–20 dB, –10 dB, 0 dB:
The volume cannot be increased above the
selected levels.
•OFF:
If you do not want to set a volume limit, select
“OFF”.
In this case, the volume can be set to the AVR-
4806’s maximum volume (output) level of +18 dB,
which is extremely loud.
2Press the CURSOR DDor HHbutton to select the
desired setting, then press the CURSOR FFor GG
button to select the parameter.
Setting the Volume Control
•Set the upper limit for the volume, the volume level when
the power is turned on, and the volume level when the mute
mode is set for the different zones.
1Press the CURSOR DDor HHbutton to select the
“Volume Control” at the “Option Setup”
menu, then press the ENTER button.
•Display the “Volume Control” screen.
Power On Level:
Set the volume that is set when the power is
turned on for the different zones.
You can adjust the volume level within the range of
–80 to +18 dB in steps of 1.0 dB.
•– – – (Mute)
The volume is always muted when the power is
turned on.
•LAST
The volume set when the AVR-4806 was last used
is stored in the memory and set when the power is
turned on.
3Press the ENTER button to enter the setting.
•The “Option Setup” menu reappears.
Mute Level:
Set the volume attenuation level when the mute
mode is set for the different zones.
•FULL
The volume is fully muted.
•–40 dB
The volume is lowered 40 dB from the current
level.
•–20 dB
The volume is lowered 20 dB from the current
level.
Volume Level:
Set whether to fix the output level for the different
zones or make it variable.
•Variable
The level can be adjusted freely using buttons on
the remote control unit.
•–40 dB, 0 dB
The output level is fixed at the set level and the
volume can no longer be adjusted.
•For ZONE2 and ZONE3, the “Volume Limit” and “Power On
Level” can be set when “Variable” is selected for “Volume
Level”.
•When the power amplifier is assigned to either of the
ZONE2 and ZONE3 channels at “Power Amp Assign”,
“–VAR–” (only variable) is displayed and the fixed level
cannot be set.
