89
Advanced Setup – Part 1
Setting the Digital In Assignment
•This setting assigns the digital input terminals of the AVR-
4806 for the different input sources.
1Press the CURSOR DDor HHbutton to select
“Audio Input Setup” at the “System Setup
Menu”, then press the ENTER button.
•Display the “Audio Input Setup” menu screen.
2Press the CURSOR DDor HHbutton to select
“Digital In Assign”, then press the ENTER
button.
•Display the “Digital In Assign” screen.
3Press the CURSOR DDor HHbutton to select the
input source, then press the CURSOR FFor GG
button to select the digital input terminal.
Select from among COAX 1 to 3, OPT 1 to 5.
If the same digital input terminal is selected, the
setting for the input source that was previously
assigned switches to “OFF”.
The HDMI input terminal is displayed when it is
assigned to the input source at “HDMI/DVI In Assign”
(page 96, 97).
If an input source is assigned to a device connected
with an IEEE1394 cable at “IEEE1394 Assign”, the
digital input connector’s assignment setting switches
to “OFF”.
If “Yes” is selected for “Default”, the settings are
automatically reset to the default values.
Audio Input Setup
•Make the audio-related settings.
4Press the ENTER button to enter the setting.
•The “Audio Input Setup” menu reappears.
•The OPTICAL 2, 3 and 4 terminals on the AVR-4806’s rear
panel are equipped with an optical digital output terminal for
recording digital audio signals to a CD recorder, MD recorder,
or other digital audio recording deck. Use this for digital
recording between a digital audio source (stereo – 2 channel)
and a digital audio recorder.
•“PHONO” and “TUNER” cannot be selected on the “Digital
In Assignment” screen.
