9 PREPARING ESPRESSO COFFEE WITH PRE-GROUND COFFEE (INSTEAD OF BEANS)
1. Press the button (fig. 16) to select the ground coffee function. This disables the coffee mill function.
The appliance displays:
READY PRE-GROUND
2. Lift the lid in the centre, place one level measure of ground coffee in the funnel (see fig. 17) and proceed
as described in section 6. NB: You can make just one coffee at a time by pressing the , or
button once only.
3. After using the appliance with pre-ground coffee, to go back to making coffee using beans, deactivate
the ground coffee function by repressing the button to prepare the grinder for operation again.
NOTE 1: Never add the ground coffee when the appliance is off to avoid it from being dispersed inside the
appliance.
NOTE 2: Never add more than 1 measure, otherwise either the appliance will not
make the coffee and the ground coffee will be lost inside the appliance, dirtying it, or
the coffee will run off in drips.
NOTE 3: When dosing the quantity of coffee to be added, use the measure supplied only.
NOTE 4: Use ground coffee for espresso coffee makers only. Do not use coffee beans, freeze-dried coffee
or other materials that could damage the appliance.
NOTE 5: If you add more than one measure of ground coffee and the funnel blocks, use a knife to push the
coffee down (fig. 18), then remove and clean the infuser and appliance as described in section 15.2
"Cleaning the infuser".
10 PRODUCING HOT WATER
1. Always make sure the appliance is ready.
2. Make sure the water spout is attached to the nozzle (fig. 4);
3. Position a container under the spout (fig. 3).
4. Press the button (fig. 1).
The appliance displays:
HOT WATER
and hot water is run off from the water spout into the container below (you should not run off hot water
for more than two minutes at a time). To stop the flow, press the button. Once the set quantity of hot
water has been reached, run-off stops automatically.
29
GB
