Foreword
Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality,performance and safety
requirements,allowing you to enjoy years of problem-free
use.
In this booklet you will find instructions for the installation
and use of your new appliance.Please read these instruc-
tions and the manual carefully to familiarize yourself with
the appliance.If you require any further support,please do
not hesitate to contact your supplier.
Unpacking
Once the heater has been unpacked,all packaging should
be disposed of in the regular manner.
Connection
This appliance should be connected by a registered
installer.
INSTRUCTIONS FOR INSTALLATION
Type of gas
This appliance can only be used and is only suitable for the
country and the type of gas mentioned on the type identi-
fication tag.Please check that the local gas and pressure
correspond with the specifications on the type identifica-
tion tag. All regulations regarding gas installation,including
any local regulations,must be observed at all times.The
appliance is to be installed by a registered installer.
To operate the heater on bultane or propane,it should be
converted by a registered installer.A conversion set can be
ordered through him.
Important
• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a
registered installer.
• Do not install any so-called dust filter on or under the
casing.
• Do not hang wet clothes and towels etc.on the heater to
dry.
General
The appliance can be mounted either on a wall of incom-
bustible material (e.g.stone or concrete) or on a wall of
combustible material (e.g.wood).
Installing the heater against a wall of
incombustible material (fig. 1)
The appliance can be installed in a hanging or standing
position. Allow at least 1 metre’s clearance above the hea-
ter to enable sufficient heat circulation.If you want to
install the appliance as low as possible,the distance from
the centre of the wall duct to the floor should be dimen-
sion F (table 1,page 9).
The mounting plate (2) serves as a stencil to mark the
position of the duct.To be able to hang the casing over the
interior,a minimal clearance of 25 mm must be allowed
between the appliance and a windowsill or suchlike.The
minimum total free height for installation is dimension Y
(table 1,page 9).
The standard wall duct
Drill a horizontal hole in the wall,ø 230mm (E) in diame-
ter, to take the air-supply pipe.The wall duct should slope
at an angle of approx.2º.
The standard wall duct is suitable for walls with a thick-
ness of 50 – 330 mm and the standard extended wall duct
for walls with a thickness of 50 – 600 mm.Depending on
the thickness of the wall,the inlet and outlet pipes should
be made to length,i.e.:
• length inlet pipe = wall thickness + 20 mm.
• length outlet pipe = wall thickness + 70 mm.
The tension members fixed to the wall grid can be made
to size after installation
Installation of the standard exterior wall duct
(fig. 3)
Slide the adjusted inlet pipe (1) through the mounting
sheet (2),with the turned-back edge facing the mark (45º
top left) in the mounting sheet.Slide the sealing ring (3)
and the wall ring (4) around the inlet pipe,paying attention
to the order (see figure).Take the whole and slide the inlet
pipe into the wall opening.Press the mounting sheet up to
10
INSTRUCTIONS FOR INSTALLATION
fig.3
