MACHINE PREPARATION
5. BATTERY MAINTENANCE AND DISPOSAL
For maintenance and recharging, comply with the instructions provided by the battery manufacturer.
Particular attention must be paid when choosing the battery charger, if not supplied, since there are
different kinds according to the type and capacity of the battery.
When the battery reaches the end of its working life, it must be disconnected by expert, trained
personnel, then lifted (using the grips and suitable lifting devices) to remove it from the battery
compartment. DEAD BATTERIES ARE CLASSIFIED AS DANGEROUS WASTE AND MUST BE
DELIVERED TO THE AUTHORISED BODIES FOR CORRECT DISPOSAL.
Proceed as follows when the battery is dead:
1. Disconnect the quick connector and remove the solution tank.
2. Open the battery compartment and disconnect the connector.
Remove the battery using suitable devices by lifting with the provided handles.
WARNING: you are advised to always wear protective gloves in order to avoid
the risk of serious injury to your hands
WARNING: You are advised to only lift and move the batteries with lifting and
transportation means suitable for the specific weight and size
6. INSERTING/CONNECTING THE BATTERIES
The machine is supplied with a built-in battery charger and an airtight gel battery. If you use batteries
other than those supplied with the machine, use only 12V AGM or Gel batteries and proceed as follows.
The batteries must be housed in the special compartment beneath the solution tank.
To insert the batteries you must:
1. Disconnect the quick connector (1) at the front of the solution tank in order to avoid breakage of the
connector itself
2. Remove the solution tank and place it on the ground
3. Open the two rear hinges (2) that close the battery compartment
4. Rotate the handlebars, raising the handlebar movement lever (see “FIXING THE HANDLEBARS”)
5. Position the battery inside the compartment
6. Connect the cables
