54
Cooking appliance
Instructions for use as a cooking appliance
WARNING: Hot surface! Risk of burns!
The mixing bowl and splash guard lid become very hot during
use.
• Therefore, always hold the rell opening (17) on the right
hand handle.
• If you open the rell opening during cooking, hot steam will
escape!
• Also watch out for the steam outlet valve (15) during cook-
ing!
• If you tilt the arm up, hot steam escapes from the mixing
bowl.
• When removing the mixing bowl, only hold it on the handles.
CAUTION:
The base of the mixing bowl becomes very hot after cooking.
• Always place the mixing bowl onto a heat-resistant surface.
NOTE:
• Enter the required settings for time, temperature and speed
in rapid succession. If you wait for longer than 5 seconds
between the individual settings, you must start entering
them again from the beginning.
• If you do not want to select one of the functions, skip the
function by pressing the button.
• If you want to change your settings, you can do it at any
time using the and / buttons.
• If you want to clear the timer or the set temperature, use the
button. Also refer to “General instructions” “Clear with
the button”.
• If the set temperature has been reached, the heating ele-
ment switches off automatically. The temperature is then
controlled by the thermostat. The current temperature is
shown on the display.
• Note the actual temperature in the mixing bowl is shown on
a time delay, since the sensor is in the base of the mixing
bowl. The delay may be approx. 5 minutes.
• After the set time has elapsed, the start screen will be
shown on the display.
• You can continue cooking after the timer has expired (max.
60 minutes) by reactiviating the timer.
• You can also cook without the timer. For safety reasons,
the appliance switches off after 15 minutes. You will see the
start screen on the display.
• You can only use a speed setting higher than setting 1 after
the mixing bowl has colled to below 60°C.
NOTE: Thermal cut-out!
The appliance is tted with a thermal cut-out. This switches off
the appliance for safety reasons, if the thermostat in the base
of the mixing bowl registers 140°C. You will hear a continuous
beep.
• Disconnect from the mains.
• Allow the appliance to cool.
• If you want to continue operation, switch the appliance back
on and select your settings again.
Operation
1. Attachment the bowl, splash guard lid and exi beater attach-
ment (23) as described under “The kneading machine”
“Assembly and operation”, points 1, 2, 4 and 5.
2. Add the ingredients to the bowl.
3. Push the arm down until it clicks into place.
4. Connect the mains plug to a properly installed earthed socket.
5. Switch the appliance on with the POWER button.
6. Press the button once. Set the cooking time of 1 to 60
minutes using the / buttons.
7. Press the button a second time. Set the temperature of
25°C to 140°C using the / buttons.
8. Press the button a third time. Set a stirring speed or a
interval using the / buttons.
9. Start the cooking program with the POWER button.
Adding ingredients
WARNING: Hot surface! Risk of burns!
Pay attention to the warnings listed above!
You do not need to pause the cooking process. Use the rell
opening in the splash guard lid.
Switching off and detaching the bowl
1. Switch the appliance off with the POWER button. Discon-
nect the mains plug.
2. Turn the knob (9) clockwise. The arm rises.
3. Turn the mixing bowl one short turn anticlockwise to detach it.
4. Take the nished food out of the bowl.
5. In order to release the attachment from the drive shaft, push it
up and turn slightly clockwise. Then pull it out.
6. Clean the used parts as described under “Cleaning”.
The Blender
Blender Use Instructions
WARNING: The knife in the blender is sharp!
• Never reach with your hands into the assembled mixing
container!
• Handle the blender knife with great car! Risk of injury,
especially when removing the knife from the mixing
container, emptying and cleaning the mixing container!
• Do not pour liquid ingredients hotter than 60°C into the
mixing container! Danger of burns!
CAUTION:
• Never turn the knob (9), if you have attached the blender
jug! The blender jug will tip over.
• Do not place hard ingredients such as nuts or coffee beans
in the mixing container.
• The knife in the mixing container is not suitable for crushing
ice cubes only.
Recommended:
• When preparing drinks with crushed ice only add the ice
cubes during mixing. The ice cubes will be crushed during
mixing.
