4
- The display shows “select bike1“,
- confirm with MR-button
-Display shows “select bike“ again
-Press LR-button shortly for a few times to select “speed“,
- confirm with MR-button
- Display shows “Speed on/off“, on is marked
- confirm with MR-button
“Iniscan SPD yes/no“ is displayed, “yes“ is marked
Now activate the speed transmitter (pick it up and gently knock the spoke magnet against the
marking of the transmitter a couple of times, this turns on the transmitter and it will give a signal.
Attention: The display of the HAC5 remains unchanged during the activation.
Confirm with MR-button (please confirm only after activating the transmitter)
Display will shortly show a percentage and returns back to selection mode after successful
initialization (display shows “speed” marked).
If the initialization is not successful, the percentage runs up to 100 % and the HAC5 shows
“Iniscan Error retry cancel“ afterwards.
- Activate transmitter once again after this and start initialization once again by selecting “retry”
(LR-button,
- confirm with MR-button).
- “cancel” (select with LR-button
- Through “cancel“ (select with LR-button and confirm with MR-button), the Initialization
function can be left (HAC5 shows the selecting menu again).
-Press LR-button once to select “CAD“
- confirm with MR-button
-Display shows “CAD on/off“, “on“ is marked
- confirm with MR-button
-Display shows “Iniscan CAD yes/no“, “yes“ is marked.
Now activate the cadence transmitter (pick it up and gently knock the spoke magnet against the
mark of the transmitter a few times, this starts the transmitter and it gives a signal.
Caution: The display of the HAC5 remains unchanged during the activation).
Confirm with MR-button (please confirm only after the transmitter is activated).
Display will shortly show a percentage and returns back to selection mode after successful
Initialization (display shows “CAD“ marked). Should the Initialization be unsuccessful see further
up.
-Press LR-button once to select “HR“
- confirm with MR-button
- Display shows “HR on/off“, “on“ is marked
- confirm with MR-button.
- Display shows “Iniscan HR yes/no“, “yes“ is marked.
If you have already put on the breast strap, it should already be activated. If not, activate it “ma-
nually“: take the strap into your hands and rub it right and left on the ribbed parts with your
thumbs, the transmitter turns on through the friction and gives a signal.
Caution: the display of the HAC5 remains unchanged during activation.
- Confirm with MR-button.
- Display now shortly shows a percentage and returns to the section menu after successful
Initialization (Display shows “HR“ marked). Should the Initialization be unsuccessful see further
up.
-Press MR-button for thr
ee seconds to leave the settings mode.
Through the settings in the “Bike1“ profile, this profile is already automatically “selected“, mea-
ning the display now shows the normal function mode of the “Bike1“ profile.
Now you can install the transmitters, the HAC5 is ready for use in terms of Initialization.
