624834
4
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
Operation Guide 5347 (OC)
E-24
General Guide
Pull out the crown to the fi rst click and then rotate it to navigate between modes. Push the crown back in
after entering the mode you want.
x Pulling out the crown to the fi rst click and then holding down B for at least two seconds will return
directly to the Timekeeping Mode.
Timekeeping Mode

x Start
x Stop
x Reset
Crown
Day Indicator
World Time Minute Hand
World Time Hour Hand
Minute Hand
Day of the Week
Hour Hand
Stopwatch
Second Hand
Stopwatch Minute Hand
(Up to 60 minutes: fi ve
12-minute revolutions)
Second Hand
A button
x Press once to start an
elapsed time operation.
B button
x Pressing once while the
2
Second Hand is indicating
normal timekeeping will
cause the
2
Second Hand to
move to A (a.m.) or P (p.m.)
for about one second.
x After last signal receive result
is indicated (page E-19), the
2
Second Hand returns to
normal timekeeping.
Pull out the crown to the fi rst click.
E-25
Stopwatch Mode

x Start
x Stop
x Reset
Crown
Minute HandHour Hand
Stopwatch Second Hand
Points to ST.
World Time Hour Hand
World Time Minute Hand
Stopwatch Minute Hand
(0 to 60 minutes)
Stopwatch 1/20 (0.05) Second Hand
World Time Mode

x Start
x Stop
x Reset
Crown
World Time Day
Indicator
World Time
Minute Hand
Stopwatch Minute Hand (Up to 60 minutes:
ve 12-minute revolutions)
Stopwatch Second Hand
World Time
Second Hand
Points to WT.
World Time
Hour Hand
Hour Hand
Minute Hand
A button
x Press once to start an elapsed time
operation.
B button
x Pressing once while the
2
Second
Hand is indicating normal
timekeeping will cause the
2
Second
Hand to move to A (a.m.) or P (p.m.)
for about one second.
x After last signal receive result is
indicated (page E-19), the
2
Second
Hand returns to normal timekeeping.
E-26
Using the Stopwatch
x Perform this operation in any mode.
A
A A A B
Start Stop Resume Stop Reset
Note
x As the
9
Day Indicator changes after you switch between the Timekeeping Mode and World Time
Mode, the
8
Mode Hand also rotates (page E-2).
x The
9
Day Indicator changes gradually at midnight each day. It take anywhere from about 90 seconds
to three minutes for the day to change.
E-27
Watch Modes
Timekeeping Mode
(Crown pulled out to fi rst click.)
World Time Mode Stopwatch Mode
In upper dial
In lower dial
In upper dial
In lower dial
In upper dial
In lower dial
x The day of the week is indicated in the Timekeeping Mode. Pulling out the crown to the fi rst click will
cause the Mode Hand to move to TM. The mode indicators to the left and right of the Mode Hand
indicate the upper and lower dial hand functions: ST (Stopwatch) for the upper dial and WT (World
Time) for the lower dial.
x In the World Time Mode, the Mode Hand points to WT. The mode indicators to the left and right
indicate the upper and lower dial hand functions: TM (Timekeeping) for the upper dial and ST
(Stopwatch) for the lower dial.
x In the Stopwatch Mode, the Mode Hand points to ST. The mode indicators to the left and right indicate
the upper and lower dial hand functions: WT (World Time) for the upper dial and TM (Timekeeping) for
the lower dial.
E-28
Selecting a City
Your watch lets you select from among city codes for 29 cities around the globe, plus one code for
UTC (Universal Coordinated Time). Selecting a city code causes the watch’s time setting to change
automatically to indicate the current time in that zone.
Important!
x You can use the same steps to select a city code in the Timekeeping mode and the World Time Mode.
x In the Timekeeping Mode, the city setting is the Home City, and in the World Time Mode, it is the World
Time City.
To select a city
Note
x This watch does not have a city code that corresponds to
Newfoundland.
1. Pull out the crown to the second click.
x This will cause the
2
Second Hand to move to the city code of
the currently selected city.
x This indicates the city code setting mode.
x Leaving the crown pulled out for more than two minutes without
performing any operation will automatically cause crown
operations to become disabled. If this happens, press the
crown back in, pull it out, and then start the operation over
again.
x For details about city codes, see the “City Code Table” at the
back of this manual.

Illustration shows Timekeeping Mode.
TYO (TOKYO)
E-29
2. Rotate the crown to move the
2
Second Hand to the city code
you want to select.
x Each time you select a city code, the
1
Hour Hand,
3
Minute
Hand,
8
Mode Hand, and
9
Day Indicator move to the current
time for that city code.
3. After the setting is way you want, push the crown back in.
x The day of the week and day will also be displayed in
accordance with the selected city code.

E-30
STD/DST Switching
You can select summer time or standard time independently for each city. The initial default setting for all
cities is AT (AUTO).
Normally you should use the AT (AUTO) setting because it automatically switches between summer time
and standard time. You should change the setting to STD (standard time) or DST (summer time) in the
following cases.
When using the watch in a city not included in the City Code Table
When the switching dates in your location are different from those shown in the City Code Table
Daylight Saving Time (DST)
Daylight Saving Time (summer time) advances the time setting by one hour from Standard Time.
Remember that not all countries or even local areas use Daylight Saving Time.
x Note that you cannot switch between STD (standard time) and DST (daylight saving time) while UTC*
is selected as the city code.
* Coordinated Universal Time, the world-wide scientifi c standard of timekeeping. The reference point for
UTC is Greenwich, England.
E-31
To switch between standard time and summer time manually
1. Pull the crown out to the second click.
x The
2
Second Hand will move to the currently selected city code.
x Leaving the crown pulled out for more than two minutes without performing any operation will
automatically cause crown operations to become disabled. If this happens, press the crown back in,
pull it out, and then start the operation over again.
2. Press A.
x The
2
Second Hand will move to the currently selected summer time setting (see table below).
x After about two seconds, the
2
Second Hand will return to the city code setting.
x Be sure to perform step 3 within two seconds after you press A (while the
2
Second Hand is
indicating the summer time setting).
AT (AUTO)
The watch automatically switches between standard time and daylight saving time in
accordance with its calendar.
STD The watch always shows standard time.
DST The watch always shows daylight saving time.
3. Hold down A for about one second to cycle through the summer time settings as shown below.
AA
AT (AUTO) STD DST
A
4. After the setting is way you want, push the crown back in.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Casio 5347 - OCW-S3001 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Casio 5347 - OCW-S3001 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,55 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info