OFF timer procedure
12 2 3 10 T
Program the switch-off time of the unit.
The unit can be either off or in operation.
After 10 seconds without pressing any button, the procedure will stop
and the remote control disply resume its original state.
1
Press button [12].
On the display the icon [T] and the hour value start flashing.
2
Time selection.
Set the hours with buttons [2] and [3]. Confirm by pressing
[9], the minutes value start flashing.
Set the minutes with [2] and [3]. Confirm the desired time by
pressing [10].
Off timer icon [T] will stop flashing.
Note
To cancel timer setting push button [12] followed by button
[10].
Daily timer
11 R
The ON and OFF timer memorization will be repeated everyday.
The unit can be either off or in operation.
1
Press button [11] to activate or activate the daily timer
function.
Icon [R] displayed signal the daily timer activation.
4
Temperature selection.
Set the desired temperature with the UP [2] and DOWN [3]
buttons.
Confirm the temperature by pressing [9]. Fan speed [M] start
flashing.
5
Fan speed selection.
Choose the fan speed with button [5]
(refer to Fan speed section).
Confirm by pressing [9]. Air flow direction [L] start flashing.
6
Air flow selection.
Choose the air flow direction with button [7]
(refer to Air flow section).
Confirm by pressing [9]. On timer icon [P] will stop flashing.
Note
During the procedure press [10] to step back and cancel the
parameters inserted.
To cancel timer setting push button [9] followed by button [10].
When the ON Timer function is operating, the unit senses the
room air temperature 1 hour before the start-up time.
The unit start might be delayed by 0 to 40 minutes, depending
on the temperature difference between the room and the
selected temperature.
