A - 14
APPENDIX
MEM ALLOC
ERROR
RESTORING
DEFAULTS
MRT COMPRES-
SION
READY
TONER LOW
TONER CART
MISSING
OPERATION CHECK
PANEL CHECK
PANEL CHECK
DONE
OPTION RAM
ERROR
OPTION ROM
ERROR
PAGES: ####
PAPER JAM
WRONG PAPER
SIZE
PRINTER OPEN
RESETTING PRINT-
ER
START PAGE
KEY NOT VALID
WARMING UP...
LOAD CLEANING
PAGE IN MANUAL
There is not enough memory available to
process the data and print the page. If AUTO-
CONT is ON (CONFIG MENU), the print job
will resume after 10 seconds.
This message is displayed when the RESET
=MENU is selected in the RESET MENU.
The printer is using MRT Compression, with
the possibility of print quality deration (lossy
compression)
Toner is low.
No toner cartridge is installed in the printer, or
the cartridge is not installed correctly.
This is the Control Panel Diagnostic Mode.
Displays during a panel check function.
Displays when panel check function is com-
plete
Option DRAM DIMM diagnostic error.
An option DRAM DIMM has failed the startup
diagnostic check.
Option DRAM DIMM diagnostic error.
An option ROM DIMM has failed its startup
diagnostic check.
This message is displayed when SHOW PAGE
COUNT is selected in the TEST MENU, where
#### is the total number of pages.
A paper jam has occurred somewhere in the
paper path.
A paper size mismatch has occurred. There is
a mismatch between the physical paper size
and the paper size requested by the job.
Printer is open.
This message is displayed when RESET
=PRINTER is selected in the RESET MENU.
This message is displayed when the printer is
printing the Start Page.
This message is displayed when a key that is
not enabled in the current function is pressed.
The printer is warming up.
Load the MP tray with the Cleaning Page gen-
erated by the printer.
If AUTOCONT is OFF, you must
press the Go key to resume print-
ing. Check the printed page to
ensure that it is complete.
No action required.
No action required.
Replace the toner cartridge. The
printer will continue to operate,
but the images will degrade.
Replace the toner cartridge or, if
cartridge is installed, remove it
and insert it again.
For detail, see Chapter 2.
Perform the troubleshooting pro-
cedure described in Section VI of
Chapter 4.
No action required.
Remove the jammed paper. The
top cover must be opened and
closed to resume printing.
The top cover must be opened and
closed to resume printing.
Close the printer.
No action required.
No action required.
Press the correct key to complete
the current function.
Wait until the printer has warmed
up and displays READY.
Press the Go key to feed the
Cleaning Page through the printer
to clean the fixing unit.
Message
Meaning
Action
