779945
173
Verklein
Vergroot
Pagina terug
1/220
Pagina verder
173
PART 3
STEP 6. Installing the Handlebar And Stem
Assembling Your Bike
Cannondale Bicycle Owner’s Manual
Remove the cardboard tube from the steering tube of the fork. You can discard, recycle, it is just
a spacer for packaging.
There will be one or more round metal spacers on the steering tube. Leave them in place.
Now take the complete stem and handlebar assembly and slide the stem over the steering tube.
Be sure that the handlebar assembly is properly oriented. A good way to check this is to be sure
that:
The shifters are facing up, towards you.
The brake lever on the right controls the rear brake. The rear brake is already connected to
the right hand brake lever, so you can squeeze the lever and see that you have the right hand
brake lever on the correct side of the bike.
The left hand brake lever will be connected to the front brake, but is not at this point.
Once you are sure that the orientation is correct, place the top cap and bolt on top of the stem.
Thread the bolt into the threaded fitting inside the steering tube. Snug this bolt with the 5 mm
allen wrench. Rock the bike forward and back a bit and snug this bolt to eliminate play. You are
setting the bearing pre-load on the headset, the bearings on which the fork pivots. You want to
tighten enough to eliminate noticeable play but want the fork to turn freely without a lot of
resistance. No torque spec here, it’s a matter of feel. Not super tight, but more than finger tight.
Now move the handlebar and stem assembly so that the stem faces directly forward. You can
sight where the front wheel will be in the fork. Once centered, use a 5mm allen wrench to tighten
the two stem clamp bolts to the spec marked on the stem or 7 Nm. You are now clamping the
handlebar and stem assembly to the steering tube and fork so that you can control the bike.
After the wheel is installed and you are doing a final pre-ride check, if you find that the handlebar
and stem assembly is not quite centered, you can loosen the two stem clamp bolts, center the
assembly and then torque the stem clamp bolts to the spec marked on the stem or 7 Nm.
173

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Cannondale Super 6 Evo - 2020 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Cannondale Super 6 Evo - 2020 in de taal/talen: Engels als bijlage per email.

De handleiding is 12.33 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Cannondale Super 6 Evo - 2020

Cannondale Super 6 Evo - 2020 Gebruiksaanwijzing - Nederlands - 102 pagina's

Cannondale Super 6 Evo - 2020 Aanvulling / aanpassing - Nederlands - 36 pagina's

Cannondale Super 6 Evo - 2020 Aanvulling / aanpassing - Deutsch - 36 pagina's

Cannondale Super 6 Evo - 2020 Aanvulling / aanpassing - English - 28 pagina's

Cannondale Super 6 Evo - 2020 Gebruiksaanwijzing - Français - 102 pagina's

Cannondale Super 6 Evo - 2020 Aanvulling / aanpassing - Français - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info