Instructions
1. CORD CAUTION: Unravel cord before use. Failure to do so could cause overheating
and possible fire hazard.
2. DISCONNECT CORD: Always disconnects cord at wall plug before removing the
heating unit, filling, cleaning, or when not in use. IMPORTANT: The heating unit will
not operate unless the plug has been disconnected from electrical outlet for about
1-2 minutes prior to reconnecting.
3. REMOVE HEATING UNIT: Lift the rear
of heating unit cap and slowly rotate
in a counter-clockwise direction until
the slanted portions of the two lock-
ing tabs is cleared. Then lift the
heating unit directly upwards until
the locking tabs are clear of the
water reservoir. (Fig. 1)
4. FILL THE CONTAINER: Fill container
with tap water to the MAX water
level marked on the water reservoir.
DO NOT OVERFILL. (Fig. 2)
5. REPLACE HEATING UNIT: Align the
two locking tabs on the side of the
heating unit with the two slots in the
water reservoir. The heating unit will
only engage the water reservoir in
the proper orientation. Seat the
heating unit into the locking tabs of
the water reservoir, then rotate the
head clockwise to hold unit in place.
6. PLACE VAPORIZER IN STABLE POSI-
TION: Vaporizer should always be
placed on a firm, flat surface at least
1.2 meters (4 feet) from bedside.
For safest operation, vaporizer should be placed on floor, where it cannot fall or be
pulled down. Be sure the power cord is out of the way to prevent vaporizer from
being upset. Protect floor, rug or furniture by placing the vaporizer on a non-metallic
heat-resistant surface.
Fig.1
Fig.2
