786182
16
Verklein
Vergroot
Pagina terug
1/85
Pagina verder
16 | English
Dust cap(4) for SDS plus fixed chuck for drilling diamet-
ers of 16−26mm
In addition, you must change the dust cap if its wall contact
surface shows clear signs of wear and is causing dust to es-
cape through the extraction brush during extraction.
Removing the dust cap(1)/(3):
Press the locking button(23) and pull the dust cap up-
wards out of the holder.
Fitting the dust cap(1)/(3):
Push the new dust cap down into the holder until the lock-
ing button audibly engages.
The extension(20) is required if you use drill bits with a total
length of 165−265mm.
Mount and remove the extension(20) according to the
assembly/removal of the dust cap.
Emptying the Dust Box (seefigureG1–G4)
Note: Wear a dust mask when performing maintenance and
cleaning on the dust box.
Empty the dust box(24) after completing your work and as
needed, in order to ensure that the dust extraction attach-
ment continues to perform optimally. The viewing
window(15) enables you to check how full the dust box is.
Hold the power tool with the dust extraction attachment
horizontally and switch on the dust extraction attachment
for a few seconds.
This will cause residual dust to be sucked out of the ex-
traction channel into the dust box(24).
Press both the left-hand and right-hand release
buttons(16) and pull the dust box(24) out of the dust
extraction attachment.
Shake out the dust box(24) over a suitable waste bin.
Press both the left-hand and right-hand locking tabs(26)
inwards and pull the HEPA filter(25) out of the dust box.
Carefully tap against the HEPA filter to empty it or brush
down the flaps of the HEPA filter using a soft brush.
Note: Do not clean the HEPA filter with water and do not
use compressed air to blow it clean.
Put the HEPA filter(25) back in the dust box(24) after
cleaning it. Then slide the dust box into the dust extrac-
tion attachment until the release buttons(16) audibly en-
gage.
Maintenance and Service
Maintenance and Cleaning
uRemove the battery from the power tool before carry-
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
uTo ensure safe and efficient operation, always keep
the power tool and the ventilation slots clean.
Clean the dust extraction attachment using a dry, soft
cloth.
After-Sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you
with any questions about our products and their accessor-
ies.
In all correspondence and spare parts orders, please always
include the 10‑digit article number given on the nameplate
of the product.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham Uxbridge
UB 9 5HJ
At www.bosch-pt.co.uk you can order spare parts or arrange
the collection of a product in need of servicing or repair.
Tel. Service: (0344) 7360109
E-Mail: boschservicecentre@bosch.com
You can find further service addresses at:
www.bosch-pt.com/serviceaddresses
Transport
The recommended lithium-ion batteries are subject to legis-
lation on the transport of dangerous goods. The user can
transport the batteries by road without further require-
ments.
When shipping by third parties (e.g.: by air transport or for-
warding agency), special requirements on packaging and la-
belling must be observed. For preparation of the item being
shipped, consulting an expert for hazardous material is re-
quired.
Dispatch battery packs only when the housing is undam-
aged. Tape or mask off open contacts and pack up the bat-
tery in such a manner that it cannot move around in the
packaging. Please also observe the possibility of more de-
tailed national regulations.
Disposal
Dust extraction attachments, batteries, ac-
cessories and packaging should be sorted for
environmentally friendly recycling.
Do not dispose of dust extraction attachments
and batteries/rechargeable batteries into
household waste!
Only for EU countries:
According to the Directive 2012/19/EU on waste electrical
and electronic equipment and its transposition into national
law, dust extraction attachments that are no longer usable,
and, according to the Directive 2006/66/EC, defective or
1 609 92A 7YA | (11.07.2022) Bosch Power Tools
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bosch GDE 18V-26 D bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bosch GDE 18V-26 D in de taal/talen: Alle talen als bijlage per email.

De handleiding is 4.47 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info