1151
20
Verklein
Vergroot
Pagina terug
1/135
Pagina verder
English - 5
20 • F016 L70 362 • TMS • 24.01.06
Important: The chain saw is not supplied
filled with oil. It is essential to fill with oil
before use. Never operate the chain saw
without chain oil or at an empty oil tank level, as
this will result in extensive damage to the prod-
uct.
Chain life and cutting capacity depend on optimum
lubrication. Therefore, the chain is automatically
oiled during operation via the oil outlet 19.
Filling oil tank:
Set chain saw on any suitable surface with oil filler
cap 4 facing upward.
Clean area around the oil filler cap 4 with cloth,
unscrew cap.
Add Bosch biodegradable chain saw oil until res-
ervoir is full.
Avoid dirt or debris entering oil tank, refit oil filler
cap 4 and tighten.
Important: To allow venting of the oil res-
ervoir,small breather channels are pro-
vided between the oil filler cap, to prevent
leakage ensure machine is left in a horizontal po-
sition (oil filler cap 4 uppermost) when not in
use.
It is important to use only the recommended bi-
odegradable oil to avoid damage to the chain
saw. Never use recycled/old oil. Use of non ap-
proved oil will invalidate the warranty.
Observe the correct mains voltage! The voltage
of the power source must agree with the value given
on the nameplate of the machine. Machines desig-
nated for 230 V can also be operated with 220 V.
Starting
Hold chain saw as described in “Cutting”.
Press the lock-off button 3, then fully press the On/
Off switch 2 and hold in this position. The lock-off
button 3 can now be released.
Stopping
Release the On/Off switch 2.
Do not stop chain saw after sawing by activating
the front hand guard (kickback brake).
The kickback brake is a safety mechanism acti-
vated through the front hand guard 5, when kickback
occurs. Chain stops immediately.
The following function check should be carried out at
regular intervals. Push front hand guard 5 forward
(position ) and start the chain saw. The chain must
not start. To deactivate the kickback brake, release
On/Off switch 2 and pull hand guard 5 backwards
(position ).
Before Cutting
Before and periodically during cutting check as fol-
lows:
Is the chain saw in a fail-safe condition?
Is the oil reservoir filled? Check oil level
gauge 26 prior to starting and regularly during op-
eration. Refill oil when oil level is low. The oil tank
filling will last approx. 15 minutes, depending on
sawing intensity and stops.
Is the chain tension in order and is the chain
sharp? Check chain tension every 10 minutes
during operation. Upon initial operation, new
chains can lengthen considerably. The condition
of the chain influences the the cutting perform-
ance. Only a sharp chain protects from overload.
Is the kickback brake deactivated and its function
ensured?
Are you wearing the necessary protective equip-
ment? Wear safety glasses and hearing protec-
tion. Further protective equipment for head, hand,
legs and feet is recommend. Adequate protective
clothing will reduce personal injury by flying de-
bris or accidental contact with saw chain.
Kickback
Kickback is the sudden backward/upward motion of
the chain saw, occuring when the chain (at the tip of
the chain bar) comes in contact with a log or wood,
or when the chain becomes jammed.
When kickback occurs the chainsaw reacts unpred-
icably and can cause severe injuries to the operator
or bystanders.
Particular attention must be given when sawing
sidewards, slanted or during length cuts, as the grip-
ping teeth 11 usually can not be applied.
To avoid kickback:
Saw with the chain bar at a flat angle.
Never work with a loose, widely stretched or the
heavily worn out chain.
Ensure chain is sharpened correctly.
Never saw above shoulder height.
Never work with the tip of the chain bar.
Always the hold chain saw firmly with both hands.
Lubrication
Starting and Stopping
A B
Kickback Brake
Cutting
D
B
D
F016 L70 362 - GB Seite 5 Mittwoch, 25. Januar 2006 8:47 08
20

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bosch AKE 35 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bosch AKE 35 in de taal/talen: Nederlands als bijlage per email.

De handleiding is 3,44 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Bosch AKE 35

Bosch AKE 35 Gebruiksaanwijzing - Nederlands, Deutsch, English, Français, Italiano, Português, Espanôl, Türkiye, Dansk, Svenska, Norsk, Suomi - 139 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info