380711
42
Verklein
Vergroot
Pagina terug
1/66
Pagina verder
ENGLISH
ENGLISH
42
CAUTION:
Do not use the mixer and the grater bowl at the same
time.
Mains Lead
Unwind the required mains lead from the base.
Initial Operation
Mixer function
1. The grater bowl (10) must be mounted as described in the
section „Positioning the Grater Bowl“ (without tool).
2. Chop the food to be mixed into small pieces.
3. Fill the mixer vessel (3) with the food to be mixed (min. 0.2 l
- max. 1.5 l). Never fi ll with hot food or hard ingredients such
as potatoes, ice, coffee beans, nuts, and so on. Do not
overfi ll! Do not exceed the maximum quantity stated on the
mixing bowl!
CAUTION: SAFETY SWITCH!
The device only works if the grater bowl (10) with lid is
also in place.
4. Put the lid (4) in place and turn it tight.
5. Close the lid with the lock (5), paying attention to the reces-
ses. Turn the lock until it is tight.
6. Place the mixing bowl (3) in position as described under
„Positioning the Mixing Bowl“.
7. If you wish to fi ll in more food to be mixed you can remove
the lid and cover. Switch the device off beforehand. Remove
the lid (4) of the mixer vessel and fi ll with the desired ingredi-
ents.
WARNING:
Do not reach into the mixer vessel, as the underlying
blade may cause injuries.
8. Place the lid on the mixer vessel again. Do not use the mixer
when empty or without the lid. Ensure that the function
switch is in the „0“ position.
9. Insert the plug in a duly installed 230 V/50 Hz socket.
10. Switch the device on (Level 1 or 2 etc.) or use pulse operati-
on (PULSE).
11. The mixing bowl must be held fi rmly in place during mixing.
12. For constant mixing (continuous mode):
When the device is operated on levels 1 to 4 the switch
locks into place in the respective position.
Level 1 = low rpm
Level 4 = high rpm
To switch the device off, turn the switch back to the „0
position.
For pulse mode (mixing at brief intervals) shift the switch
to „0“ position. The appliance is off now. Please press the
PULSE (20) button. Keep the button pressed down in this
position according to the desired interval length. When
the button is released, it automatically returns to the „off“
position.
13. In order to remove the mixer jug turn it counterclockwise.
14. Clean the used parts as described in „Cleaning“.
Mixing bowl
The cover of the mixer drive (7) must be mounted as descri-
bed above.
Mount the grater bowl as described under „Positioning the
Mixing Bowl“.
Place the locating pin over the drive shaft (Illustration 5).
The metal point faces upwards.
Never use more than one utensil at a time.
Dough kneading and beating
1. Take the plastic blade (16) for preparing the dough and
attach it to the locating pin. Then press the Messer down as
far as it will go (Illustration 6).
2. Now ll in your ingredients. Please note the markings on the
processor bowl and do not fi ll it above them (min 0.2 l - max.
0.8 l).
3. Place the lid in position on the processor bowl. Turn it tight
until it is clearly heard to lock in place (Illustration 7).
4. Close the opening in the lid with the stopper (17).
5. Insert the plug into a 230 V / 50 Hz socket installed accor-
ding to existing regulations and with earthing protection.
Switch on the appliance and set a speed between 1 and 3
(See table) with switch (1).
When the device is operated on levels 1 to 4 the switch
locks into place in the respective position.
Level 1 = low rpm
Level 4 = high rpm
To switch the device off, turn the switch back to the „0
position.
For pulse mode (Operating at short intervals) shift the switch
to „0“ position. The appliance is off now. Please press the
PULSE (20) button. Keep the button pressed down in this
position according to the desired interval length. When
the button is released, it automatically returns to the „off“
position.
With this device it is possible within a very short time:
up to 600 g of heavy dough (bread or pastry),
beat up to 800 g of crepe or waffl e batter,
beat up to 800 g of light dough (e.g. for cookies).
ޥ NOTE:
Do not exceed the short operation times stated in the table
when kneading the dough!
6. After kneading/stirring turn the switch (1) back to position
0“ as soon as a small amount or ball of dough has formed.
Then remove the mains plug.
7. Turn the lid to the left and remove it from the processor
bowl.
8. Pull the blade off from the locating pin.
9. Release and remove the grater bowl and the locating pin.
The fi nished dough can be released from the sides and with
a spatula (18) and taken out of the bowl.
10. Clean the used parts as described in „Cleaning“.
05-KM 345 CB 42 14.11.2006, 9:27:59 Uhr
42

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bomann km 345 cb bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bomann km 345 cb in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Noors als bijlage per email.

De handleiding is 3,03 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info