364279
17
Verklein
Vergroot
Pagina terug
1/84
Pagina verder
21
Position the tube so that the liquid
is able to fl ow out while cleaning.
Insert the tip of the cleaning
balloon into the tube in the
arrowed direction and place the
end of the opposite tube in a
suitable container with warm water.
Thoroughly rinse out the tube repeatedly by fi rmly
squeezing the balloon.
Refi t the tube and close the cover.
NOTE
:
It is recommended to use hot water and a small amount
of washing-up liquid. In this case, the tube should be
rinsed again with clear, warm water in order not to
prevent impairment of the taste and foam formation.
Cleaning after emptying a 5 litre party keg
Each time a keg is emptied, the dispensing unit must be
thoroughly cleaned in addition to the collecting tray, drip
tray and tube. The cleaning balloon should be used for this
purpose.
Position the dispensing unit so that
the liquid is able to fl ow out while
cleaning.
Remove the cover located at the front below the beer
tap.
Open the beer tap and fi x it in this position by pulling
the tap handle until it locks.
Insert the tip of the cleaning balloon into the
dispensing tube in the arrowed direction and place
the end of the opposite tube in a suitable container
with warm water.
Thoroughly rinse out the dispensing tube by fi rmly
squeezing the balloon.
NOTE
:
It is recommended to use hot water and a small
amount of washing-up liquid. In this case, the
dispensing tube should be rinsed again with clear,
warm water in order not to prevent impairment of
the taste and foam formation.
Disinfectant cleaners in powder form for beer and
drinks systems are available from off-licences,
which are ideal for cleaning the beer dispenser.
ATTENTION!
The dispensing unit is not dishwasher proof.
If the dispenser is not used for an extended period,
it should be thoroughly cleaned beforehand.
Regular cleaning
Regularly clean the cooling chamber and all surfaces of
the dispenser with a moist cloth and small amount of mild
washing-up liquid.
ATTENTION!
Before cleaning the dispenser, always disconnect
the plug from the mains socket and never immerse
the dispenser in water!
The cooling chamber must not be fi lled with liquid
as this can cause permanent damage!
Troubleshooting
Problem Possible cause Remedy
The unit does not
switch on.
The plug is not
plugged into the
mains socket.
The main switch
is set to "0".
Plug the plug into
the mains socket.
Set the main
switch to "I".
No beer is
dispensed.
The 5 litre party
keg is empty
or there is not
a 5 litre party
keg in the beer
dispenser.
Place a new 5
litre party keg in
the dispenser.
The CO2
cartridge is
empty.
Change the CO2
cartridge.
The keg tap is not
tted. The keg
is not correctly
tapped.
Screw the keg tap
to the dispensing
unit. Tap the keg
correctly.
The tap handle
is not correctly
installed.
Install the tap
handle correctly.
Too much foam
is produced when
dispensing.
The 5 litre party
keg is not cold
enough.
Cool the 5 litre
party keg longer.
The 5 litre party
keg was shaken.
Allow the 5
litre part keg to
stand in the beer
dispenser for a
while.
The beer does
not fl ow freely out
of the tube.
Open the beer
tap fully.
The outlet tube
touches the glass
when dispensing.
Hold the glass
slightly further
away from the
outlet tube.
ENGLISH
17

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bomann bz 9482 cb bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bomann bz 9482 cb in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Pools als bijlage per email.

De handleiding is 6,11 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Bomann bz 9482 cb

Bomann bz 9482 cb Gebruiksaanwijzing - Nederlands, Deutsch, English, Français, Italiano, Espanõl, Polski - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info