Basic Operations
Charging Your Headset
Prior to using the headset for the first time, please fully charge the battery.
Approximately 2 hours are required to fully charge the headset.
The indicator light turns red while being charged, and will turn to blue after being
fully charged.
When the headset is running out of battery, the indicator light will flash red every
20 seconds and will beep every 20 seconds (the headset will switch off
automatically when the battery is drained). Please charge the headset as above
steps in time to prolong the battery's useful life (Charging indication will be
delayed for a few minutes if the headset has not been used for a long time or the
battery is drained).
Note:
Use only the supplied charger to charge the headset, or could be dangerous.
Do not attempt to force open the built-in battery as this could damage the
headset.
If left unused, a fully charged headset will loose its power automatically. It is
recommended to charge the headset every three months.
Do not leave the headset in a too hot or too cold condition (best between
15℃and 25℃) which may affect the headset's operations.
Do not dispose of the headset into a fire and water.
Note:
The headset can be used not only for the Blaupunkt MotoPilot, but also with any
Bluetooth-enabled mobile phone. Some of the following information refers solely
to the use with mobile phones (e.g. answering calls etc.). For the use with
Blaupunkt MotoPilot you need only the Pairing and Volume adjust. The voice
acting is done automatically without pressing the MFB or else a button while
driving.
Turning on the Headset
In OFF MODE, press and hold MFB for 2 seconds until you hear a short beep
and the indicator light flashes blue for 4 times, then the headset will enter into
STANDBY MODE.
Turning off the Headset
In ON MODE, press and hold MFB for 5 seconds until you hear a short beep and
the indicator light flashes red for 4 times, then the headset will enter into OFF
MODE.
