Operating the appliance en
29
Remaining running time
display
When the programme is selected, the
remaining programme time is indicated
in the display window h.
*After the programme has started, the
remaining running time is displayed on
the floor (only for settings Timelight
†:‹‚ and †:‹ƒ).
The running time is determined during
the programme by the water
temperature, the quantity of dishes as
well as the degree of soiling and may
vary (depending on the selected
programme).
* depending on the features of your
dishwasher
Time preselection *
Ti me pr esel ect i on
* depending on the configuration of
your specific dishwasher
You can delay the start of the
programme in hourly steps by up to 24
hours.
Here’s how to set up the delay:
1. Switch on ON/OFF switch (.
2. Press the timer programming button
P + repeatedly until h œ ‹‚
appears in the display window.
3. Keep pressing the timer
programming button P - or + until
the desired time is displayed.
4. Press START button `.
The delay timer has been activated.
5. To clear the specified delay, press
the button P - or + repeatedly until
h œ ‹‹ appears in the display
window.
Until the programme has started, you
can change your selection in any way
you like.
Programme end
The programme has finished when the
value ‹:‹‹ appears in the display
window h. If a value has been set for
the signal volume, then the end of the
programme is also indicated by a
buzzer.
Here’s how to change the signal
volume:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button ` until •:‹...
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the digital display h shows
the factory setting •:‹….
4. Press the programme button #
repeatedly until the factory setting
value ›:‹ƒ appears in the display
window h.
5. Press the programme button 3.
Each time the button is pressed the
set value increases by one level;
when it reaches the value ›:‹„ the
display jumps back to ›:‹‹ (off).
6. Press START button `.
The set value is saved.
* The end of the programme is
displayed n the floor (only for the
settings Timelight †:‹‚ and †:‹ƒ).
* depending on the features of your
dishwasher
