en Operating the appliance
28
timeLight (optical display
while a programme
is running) *
ti meLi ght
* depending on the configuration of
your specific dishwasher
While a programme is running, an
optical display (additional programme
information) is projected onto the floor
at the bottom of the appliance door. If
the base panel is pulled forwards or if
the appliance is installed at eye-level
flush with the furniture then this display
will not be visible.
Possible settings of the optical
display:
The setting †:‹‚ is set up at the factory.
Here’s how to change the setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then hold the START button
` until •:‹... appears in the
display window h.
3. Release both buttons.
The illuminated display on the button
# flashes.
4. Press the programme button #
repeatedly until †:‹... appears in the
display window h. (for the optical
display) together with the previously
set value, for example †:‹‚.
5. Press the programme button 3
repeatedly until the desired value, for
example †:‹‹, appears in the
display window h.
6. Press START button `.
The set value is saved.
infoLight (optical display while
a programme is running) *
i nf oLi ght
* depending on the configuration of
your specific dishwasher
While a programme is running, a light
spot is projected onto the floor at the
bottom of the dishwasher door. Do not
open the dishwasher door until the light
spot is no longer visible on the floor. If
the door is not properly closed the light
spot will flash.* If the appliance is
installed at eye-level flush with the
furniture, this display will not be visible.
Here’s how to change the setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button ` until •:‹....
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the display window h lights
up to show the value •:‹...
4. Press the programme button #
repeatedly until the factory setting
value ‚:‹‚ appears in the display
window h.
5. Press the 3 button to switch the
function on ‚:‹‹ or off ‚:‹‚.
6. Press START button `.
The set value is saved.
†:‹‹ The display is switched off.
†:‹‚
/
†:‹ƒ
The display can show the
programme, the timed delay,
remaining time and end of the
programme.
