779501
35
Verklein
Vergroot
Pagina terug
1/87
Pagina verder
68 69
MTB-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2016 ORIGINAL OPERATING INSTRUCTIONS 2016 | MTB-PEDELEC
b ca e fd
ENGLISH
ENGLISH
To measure the travel you can use the rubber ring mainly located on the thinner,
plunging tube of the suspension fork. If there is no rubber ring, tie up a cable tie
around one of the stanchion tubes. Make sure it is not too tight, you should still
be able to move it, it should however not slip by itself.
Put on your usual riding clothing (including if necessary a packed rucksack),
sit on your bike and bring yourself into the usual riding position. Lean against a
fixed object (railings, wall etc.) and make sure you do not fall over. Ask a helper
to move the rubber ring or the cable tie downwards against the dust seal at the
lower leg.
Get off your BERGAMONT bike so that the fork does not compress any more.
The distance between the rubber ring/cable tie and the wiper is the negative
suspension travel, or sag (d). Compare it with the total suspension travel (as
specified by the manufacturer) to determine whether the suspension should be
set to be harder or softer.
With pneumatic suspension forks the spring rate is set by the air pressure in
the fork. The pressure must be set before the first ride by means of a special
high-pressure pump with pressure gauge (e) and modified later as required due
to changes in the weight of the rider and/or load.
Note the appropriate setting values and check them subsequently at regular
intervals. Always follow the recommendations of the manufacturer and never
exceed the maximum air pressure for the suspension fork. Always make a test
ride after each change to the settings.
In the case of most suspension forks with coil springs a preload can be applied
to the springs within tight limits by turning a knob at the top of the fork crown
(f). If that is not possible and the desired negative suspension travel (“sag”)
cannot be set, the coil springs must be replaced by harder or softer models. The
replacement is a job for the BERGAMONT dealer.
When replacing any parts, be sure to only use parts that bear the appropriate
mark and, to be on the safe side, original spare parts. Your BERGAMONT dealer
will be pleased to help you.
FRONT SUSPENSION
Most of the BERGAMONT mountain bikes (a) and BERGAMONT pedelecs
(b) have suspension forks. This feature gives you better control of your
BERGAMONT bike when riding cross-country or on rough road surfaces and
ensures more ground contact for the tyre. It noticeably reduces the strain on
you and your bicycle caused by the mechanical shocks from the terrain.
Suspension forks differ in their types of spring elements and damping. Suspen-
sion forks normally work with air spring elements or less often with coil springs.
Damping is usually done by oil.
NOTE!
I
Suspension fork manufacturers normally include instructions with their
deliveries. Read them carefully before changing any settings or doing any
maintenance work on your suspension fork. You can find the instruction of the
suspension fork manufacturer on this BERGAMONT info CD.
NOTE!
I
For more information see the suspension glossary heading this chapter.
Adjusting the spring rate
To work perfectly, the suspension fork has to be adjusted to the weight of the
rider, the sitting posture and the intended use. Be sure to have this adjustment
carried out by your BERGAMONT dealer at the time of delivery.
Note in general that the suspension fork must give in a little even when you are
just sitting on the bike – this is the so-called negative suspension travel or sag
(c). When the front wheel passes through a depression in the ground, the spring
extends and the suspension fork will smooth out the uneven surface. If the air
pressure or the spring preload is too high, this effect is lost because the suspen-
sion fork is already fully extended. This means that an important comfort and
safety factor is lost if the tyre briefly loses contact with the ground.
In general, cross-country and marathon racers prefer a shorter negative sus-
pension travel (sag), whereas freeriders or downhillers riding often in rough
terrain prefer a longer one.. In the case of BERGAMONT cross-country and
BERGAMONT marathon bikes the suspension fork should yield by 15-25 % of
the maximum suspension travel, in the case of BERGAMONT all mountain,
BERGAMONT enduro and BERGAMONT freeride bikes by 25-35 %.
35

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bergamont Pedelec 2016 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bergamont Pedelec 2016 in de taal/talen: Engels als bijlage per email.

De handleiding is 21.14 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info