Advanced programming
Advanced programming provides additional options for those who wish to make special
modications to the wrist receiver.
The idea is that it should be possible to select a completely unique signal pattern which is
linked to activation from a specic input on a specic transmitter. The function works regard-
less of the radio key settings on the units that are programmed. Please note that, for safety
reasons, the function does not work with the Visit smoke alarm transmitter.
By using advanced programming of the wrist receiver, it can be adjusted so that its signal
pattern corresponds exactly to what is required. In other words, an entirely individual signal
pattern can be programmed, such as displaying a permanently lit orange LED and a constant
vibration.
In order to adjust the setting, the transmitter to which the wrist receiver should be adapted
must be available. The transmitter must also be connected so that it can be activated in the
way in which it is intended to be used.
Proceed as follows
1 Hold down the function button (1) on the wrist receiver until the green (3) and yellow
(4) LEDs blink alternately. The wrist receiver will now be in programming mode for
about 30 seconds.
2 Hold down the function button (1) at the same time as the relevant transmitter is acti-
vated in the way in which it is intended to be used. The yellow LED (6) will light up.
Note that all inputs are individual, so that it is not possible to use the test button on the
telephone transmitter whose telephone input will indicate the relevant pattern.
3 Scroll through the dierent LED options by a short press on the function button (1). Select
the relevant indication by holding down the function button (1) until the LED (6) goes
out and starts to shine with a constant yellow light again.
4 Scroll through the dierent vibration options by a short press on the function button (1).
Select the relevant indication by holding down the function button (1) until the LED (6)
goes out and starts to shine with a constant yellow light again.
5 The wrist receiver will now show the indication method programmed. End the display
with a short press of the function button (1).
6 After a short while the wrist receiver will automatically return to normal mode.
Resetting advanced programming
It is quite easy to reset the wrist receiver if it needs to be reset after it has been programmed
116
