7
Overview of programmes a refer to the table of consumption values on page 8 and notes on page 6.
Programmes °C max.
T
Additional functions; infor
algodón/algodão (cottons)
frio (cold), 20, 40,
60, 90 °C
6 kg
Hard-wearing fabrics, heat-resistant fabrics made of
cotton or linen
]centrif., flot (no spin)
algodón/algodão eco
(cottons eco)
40, 60 °C
algodón/algodão + prelav
(cottons + prew
60 °C
sintéticos (easy-care) frio (cold), 40 °C 3 kg
Easy-care fabrics made of cotton, linen, synthetic
fibres or blended fabrics
]centrif., flot (no spin)
delicado (delicates) frio (cold)
2 kg
For delicate, washable fabrics, e.g. made of silk, satin,
synthetic fibres or blended fabrics (e.g. curtains)
]centrif., flot (no spin);
No spin between rinse cycles
ÿ / lana/lã (wool) frio (cold),
Handä or machine-washable fabrics made of wool or
containing wool
Particularly gentle wash programme to prevent
shrinkage of laundry. Longer programme breaks
(fabrics rest in the detergent solution)
Additional programmes 5 (rinse), 6 (spin), 4 plus (empty)
Programmes without prewash - add detergent to compartment II , programmes with prewash - distribute the detergent between compartments I and II
(depending on model ).
9306 / 9000895776
*895776*
3TS60106A ...
Balay Electrogeräte GmbH
Carlä Wery Str. 34
81739 Munich / Alemania
8
Safety instructions
– Read
with the washing machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock – Never pull the cable to disconnect the mains plug.
– Never insert/disconnect the mains plug with damp hands.
Danger to life For worn-out appliances:
– Disconnect the mains plug.
– Sever the mains cable and discard along with the plug.
– Destroy the lock on
children from locking themselves in and risking their lives.
Danger of suffocation – Keep packaging, film and packaging parts out of the reach of
children.
Risk of poisoning – Keep detergents and care products out of the reach of children.
Risk of explosion – Items of laundry pretreated with cleaning agents containing
solvents, e.g. stain remover/cleaning solvent may cause an
explosion after being loaded into the washing machine.
Rinse items of laundry thoroughly by hand beforehand.
Risk of injury – The washing machine door can become very hot.
– Be careful when draining hot detergent solution.
– Do not climb onto the washing machine.
– Do not lean on the open washing machine door.
– Do not reach into the drum if it is still rotating.
– Be
is in operation.
Consumption values depending on model
Programme Load Electricity*** Water***
Programme
duration
***
algodón/algodão eco
(cottons eco) 40 °C*
6 kg 0,85 kWh 58 l 01:50 h
algodón/algodão (cottons) 60 °C* 6 kg 1,40 kWh 57 l 02:05 h
algodón/algodão (cottons) 90 °C 6 kg 2,10 kWh 62 l 02:05 h
sintéticos (easy-care) 40 °C* 3 kg 0,55 kWh 48 l 01:15 h
delicado (delicates) frío (cold) 2 kg 0,28 kWh 48 l 00:44 h
ÿ / lana/lã (Wool) frío (cold) 2 kg 0,20 kWh 32 l 00:53 h
* Pro
Note on comparative tests: For testing the test programmes, wash the specified load using the maximum spin speed
(depending on model ).
Programme Load
Annual energy
consumption
Annual water
consumption
algodón/algodão eco (cottons eco) 40/60 °C** 6/3kg 193 kWh 9600 l
** Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 ºC).
*** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient tem-
perature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional
functions.
9
Care
Before washing for th
Do not load any laundry into the machine. Turn on the tap. Add the following to
compartment II :
– approx. 1 litre water
– detergent (dosage according to the manufacturer's instructions for light soiling and the
appropriate degree of water hardness)
Set algodón/algodão inicio .
At the end of the programme, turn the programme selector to stop (off) .
Machine housing, control panel
– Wipe with a soft, damp cloth.
– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
– Remove detergent and cleaning agent residue immediately.
– Do not clean with a jet of water.
Cleaning the detergent drawer and housing...
...if it contains detergent or fabric softener residues.
1. Pull the drawer out, press down the insert and fully remove the drawer
from the housing.
2. To remove the insert: press the insert upwards from below with your
finger.
3. Clean
dry it. Also remove any detergent or fabric softener residues in the
housing.
4. Attach the insert and engage (connect the cylinder to the guide pin).
5. Push in the detergent drawer.
Leave the detergent drawer open so that any residual water can
evaporate.
W
Wipe
that the drum can dry out. Rust stains - use chlorine-free cleaning agent, not steel wool.
Descaling Ensure there is no laundry in the machine
Descale
be necessary if the correct dosage of detergent is used.
Information to indicator lights
Indicator lights for status displays and/or buttons flash:
Indicator lights
5c(rinse) and
þü(wash) flash
Close the washing machine door properly; laundry may be caught.
Indicator lights
6c(spin) and
þü(wash) flash
Open the tap completely, supply hose kinked or trapped;
Clean the filter a page 10 , Water pressure too low.
Indicator lights
6c(spin) and
5c(rinse) flash
Detergent solution pump blocked; Clean the detergent solution pump
a page 10.
Drainage hose/waste pipe blocked; Clean the drainage hose at the
siphon a page 10 .
Indicator light
5c(rinse) flashes
Motor fault. Call the after-sales service.
All indicator lights flash Turn off the tap and call the after-sales service.
– Risk of electric shock.
Disconnect the mains plug.
– Risk of explosion. No solvents.
1
Maintenance
Detergent solution pump
Turn the programme selector to stop (off) and disconnect the mains plug.
1. Open and remove the service flap.
2. For models with
from the housing. Remove the container.
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
2* For models without a drainage hose: Carefully unscrew the pump cover until the
detergent solution
and empty the service flap. Repeat the above steps until all the detergent solution has
completely drained out.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (the impeller in the detergent
solution pump must rotate).
5. Replace the pump cover and screw it in place tightly.
6. Place the service flap back on and close.
To prevent unused detergent from flowing straight into the drain during the next wash: Pour 1 litre of water into
compartment II and start the 4 plus (empty) programme.
Drainage hose at the siphon
Turn the programme selector to stop (off) and disconnect the mains plug.
1. Loosen the hose clamp, carefully remove the drainage hose (residual water).
2. Clean the drainage hose and siphon connecting piece.
3. Reattach the drainage hose and secure the connection with the hose clamp.
Filter in the water suppl
Reduce the water pressure in the supply hose:
1. Turn off the tap.
2. Select any programme (except for 6 (spin) // 4 plus (empty) ).
3. Select inicio (start) . Let the programme run for approximately 40 seconds.
4. Turn the programme selector to stop (off) . Disconnect the mains plug.
Clean the filter:
1. Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and Aqua-Secure models:
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
2. Connect the hose and check for leaks.
– Risk of scalding.
Allow the detergent solution to cool down.
– Turn off the tap.
1
What to do if...
ʑ
Water is leaking out. – Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
ʑ
No water supply.
Detergent not dispensed.
– inicio (start) not selected?
– Tap not turned on?
– Filter blocked? Clean the filter a page 10.
– Supply hose kinked or trapped?
ʑ
Washing
be opened.
– Safety function active. Wait approx. 2 minutes.
– flot (no spin) (without final spin) selected? a page 3, 4.
ʑ
Programme does not start. – inicio (start) selected?
– Washing machine door closed?
ʑ
Detergent solution is not
drained.
– flot (no spin) (without final spin) selected? a page 3, 4.
– Clean the detergent solution pump a page 10.
– Clean the waste pipe and/or drainage hose.
ʑ
Water not visible in the drum. – Not a fault - water below the visible area.
ʑ
Unsatisfactory spin result.
Laundry wet/too damp.
– Not a fault - the unbalanced-load detection system has cancelled the spin
cycle because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the drum.
– Too low a speed selected? a page 5 .
ʑ
Spin cycle performed several
times.
– Not a fault - unbalanced load detection system adjusts the imbalance.
ʑ
Residual water in the
compartment for care
products.
– Not a fault - the action of the care product is not affected.
– Clean the insert if necessary a page 9 .
ʑ
Odour formation in the
washing machine.
– Run programme algodón/algodão (cottons) 90 °C without laundry. Use
standard detergent.
ʑ
Foam escaping from the
detergent drawer.
– Too much detergent used?
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
ʑ
Intense noise formation,
vibrations and “walking”
during the spin cycle.
– Are the appliance feet fixed?
Secure the appliance feet a Installation instructions .
– Transportation safety devices removed?
Remove the transportation safety devices a Installation instructions .
ʑ
Noises during spin and drain
cycles.
– Clean detergent-solution pump a p
ʑ
The indicator lights do not
function during operation.
– Power cut?
– Fuses tripped? Reset/change the fuse.
– If the fault occurs repeatedly, call the after-sales service.
ʑ
Programme sequence longer
than usual.
– Not a fault - unbalanced load detection system adjusts imbalance by
repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse cycle.
ʑ
Detergent residues on the
laundry.
– Occasionally, phosphate-free detergents contain water-insoluble residues.
– Select
5 (rinse) or brush out the laundry after washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to stop (off) and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service a Installation instructions.
Instruction manual
en
Washing
machine
Observe the safety instructions on page 8!
Read these
installation instructions before operating
the washing machine.
