INSTALLATION
Arada Farringdon 16 20
Catalyst Replacement
The catalyst in your Farringdon 16 wood stove should be replaced after
approximately 12,000 hours of burning, or if you notice a darkening of the
smoke omitted from your chimney.
The catalyst should be replaced every 5 to 6 years irrespective of hours
burned.
Replace with only a genuine Arada Catalyst
Part No. CatFAR16.01 detailed on page 33.
The performance of the catalytic device or it durability has not been evaluated
as part of the EPA certification
Replace as detailed below.
Farringdon Catalyst
P/No. CatFAR16.01
Sit the new catalyst on the cover plate as shown in Fig. 6,
(approximately central) offer the cat and cover plate back up to
the stove gently sliding the catalyst through the aperture.
Do not remove the CatGard wrap or the white tape secur-
ing it in place, this form the seal on first firing.
Remove the throat plate as detailed on page 19,
Remove the 5 domed nuts and withdraw the
catalyst cover and catalyst (Fig.5 & 6).
Discard the old catalyst in accordance with local
regulations.
Replace and tighten the 5 domed nuts, shown by red
high lights firmly but do not over tighten (Fig.7).
Refit throat plate as detailed on page 19.
Fig. 5.
Fig. 6.
Fig. 7.
