INSTALLATION
Arada Farringdon 16 19
Overall View Of Liners & Throat Plate Assembly
Back side liners
2 per side
Fig. 2.
Fig. 3.
Side air ducts
Front side
liner
1 per side
Rear liners 2 off
Throat plate sat
correctly on air tube
and rear air bar.
Note: Insulation
blanket not shown
FIREBOX LINER PANELS
The Arada Farringdon stove uses firebox liner
panels to the sides and back. The throat plate sits
on top of the perforated air tube at the front and
into two slots in the rear air bar. These parts
should come fitted to your stove, if however they
are not, proceed as follows to fit them.
• Open the fire door.
• Remove the fuel retaining bar, by lifting free
of the retaining slots.
• Set the rear liner (s) into the back of the
firebox.
• Lift the throat plate into position with the
front above the perforated air tube. Align
the 2 tabs on the throat plate with the
location slots in the rear air bar and drop
into position (See Fig 4)
• Insert one of the side liner panels in each
side at the back sitting on the side landing.
Lift up one at a time past the throat pate
as far as it will go and slide in the lower liner
side liner.
Repeat for the other set of rear side liners.
(See Fig 2&3)
• Insert one front side liner in each side
of the front of the stove. Secure in place with
the front liner clamp as shown.
(See Fig 2&3)
Note: Neither the rear firebox liners nor the
side firebox liners are ‘handed’, both faces are
suitable for direct contact with the fire bed.
Note : Cracking of the liner panels does not
effect efficiency.
Front liner
securing
clamp
Fig. 4.
Throat plate
location tab
and slot in
rear air bar
