731917
20
Verklein
Vergroot
Pagina terug
1/27
Pagina verder
7
Carefully open the fuel tank cap to allow the
pressure inside to decrease gradually. Use
a funnel to rell and avoid lling the tank to
the brim.
WARNING! Always close the fuel tank
cap firmly.
WARNING! Immediately clean all traces
of fuel which may have dripped on the ma-
chine or the ground and do not start the en-
gine until the petrol fumes have dissipated.
3. USING THE MACHINE
3.1 STARTING THE MACHINE
WARNING! The machine must be started
in an area at least 3 metres from where you
refilled the fuel tank.
Before starting the engine:
Place the machine rmly on the ground.
3.1.1 Cold starting
WARNING! A “cold” start of the engine
means starting it after at least 5 minutes from
when it was switched off or after refuelling.
To start the machine (Fig. 5):
1. Set the switch (1) to position «I».
2. Operate the choke, turning the lever (4) to the
«B» position”.
3. Press the primer device button (5) 3 or 4 times
to prime the carburettor.
4 Press the safety lever (3), activate the throttle
trigger (2) and hold it in this position using
the shutter button (7); then release the safety
lever (3).
5. Hold the machine rmly on the ground with
one hand on the power unit, in order not to lose
control of the machine during startup (Fig. 6).
IMPORTANT To prevent distortions, the drive
tube must not be used as a support for the hand
or knee during startup.
6. Pull the starter grip slowly for 10 - 15 cm un-
til you feel some resistance, then tug it a few
times until you hear the engine turn over.
IMPORTANT To avoid breaking the starter ca-
ble, do not pull the whole length of it or let it slide
along the edge of the cable guide hole. Release
the starter grip gradually, to avoid letting it fly back
uncontrollably.
7. Pull the starter grip again until the engine
starts as normal.
WARNING! Starting the engine with the
choke engaged causes the cutting device to
move, only stopping when the choke is dis-
connected.
8. When the engine is started, disconnect the
starter by turning the lever (2) to «ON».
9. Disconnect the shutter (7 - if provided) briey
activating the throttle trigger (2), to take the
engine back to minimum speed.
10. Let the engine run idle for at least 1 minute
before using the machine.
IMPORTANT If the starter grip is pulled repeated-
ly with the choke on, it may flood the engine and
make starting difficult.
If you have ooded the engine, remove the spark
plug and gently pull the starter grip to eliminate
any excess fuel; then dry the spark plug elec-
trodes and replace it on the engine.
3.1.2 Warm starting
When warm starting (immediately after stop-
ping the engine), follow the procedure indicated
above in points 1-5-6-7.
3.2 ADJUSTING THE SPEED
OF THE CUTTING DEVICE (Fig. 5)
Cutting device speed is regulated by the throttle
trigger (2), located on the rear handgrip (6).
The throttle trigger only works if the lockout (3) is
pressed at the same time.
The movement is transmitted from the engine
to the transmission shaft by a centrifugal mass
clutch that prevents the shaft from moving when
the engine is running at minimum speed.
WARNING! The cutting device must not
move when the engine is running idle. If the
cutting device moves when the engine is
running idle, contact your dealer to correctly
regulate the engine.
The correct running speed will be achieved by
pressing the throttle trigger (2) as far as possible.
IMPORTANT Avoid using the engine at full pow-
er for the first 6-8 working hours.
3.3 STOPPING THE MACHINE (Fig. 5)
To stop the machine:
Release the throttle trigger (2) and allow the
engine to run idle for a few seconds.
20

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alpina ABR 26 JD bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alpina ABR 26 JD in de taal/talen: Alle talen als bijlage per email.

De handleiding is 1,84 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info