72
Something not Working
Problems may be due to causes which can easily be solved before
calling the Technical Service. Please follow these instructions:
SYMPTOM
Door does not close
It is too warm inside the
refrigerator
It is too cold inside the
refrigerator.
The compressor works
continuously.
There is water inside/outside
the refrigerator.
Water comes out on the
floor.
Noises
SOLUTION
Level properly the appliances if it is not well levelled.
Weight surpasses the storage limit of the door shelf so
spread weight more evenly or take some products out.
The appliance is not properly installed. Please look in the
“Building-in” section.
Set a lower temperature.
Distribute the food products to allow cold air to
circulate around them.
Make sure that the door is completely closed and that
the insulating strip is complete and clean.
The temperature where the cabinet is placed is above
normal room temperature.
Turn the temperature regulator to a warmer setting
temporarily.
Turn the thermostat knob to a lower number.
The temperature where the cabinet is placed is above
normal room temperature.
Check that the ventilation is sufficient and that the
ventilation openings are unobstructed.
The cause could be the introduction of large quantities
of food and/or frequent opening/closing of the door.
Sometimes is normal. During automatic defrosting frost
thaws on the cooling plate.
Place the drain hose at the back of the cabinet above
the drain bowl.
Sometimes this is normal. Temperature control may
cause clicking sounds when the system is connected or
disconnected.
The injected cooling gas may produce a gurgling sound
while passing through the tubes.
The motor may cause a humming noise and/or slight
bumping.
The insulation material used has a tendency to slighly
increase noise levels, how ever it allows for much better
insulation and a lower energy consumption.