10
How to check alarm settings
Set alarms will be shown by when entering ALARM setting mode.
Push and hold the ALARM button for 2 seconds. Leave the
ALARM setting mode by pushing the same button for another 2
seconds.
Be aware that if an alarm is set on 7 am it will be presented with a
fast flashing light, since the cursor will be located there when
entering programming mode.
How to delete alarms
To delete single alarms, use the same procedure as for setting
alarms.
To delete all alarms simultaneously:
Enter programming mode by pushing the ALARM button for 2
seconds.
Push and hold both switches (ALARM and TIME) for 1 second.
The Memodayplanner will acknowledge with a beep for 2
seconds.
Leave the alarm setting mode by pressing the ALARM button
for 2 seconds or do nothing for 1 minute (automatic timeout).
How to disable a blinking alarm light
Some users prefer the light to remain steady and not flash during
an alarm. To disable this function switch number 2 on the back
(see picture 2) should be in down position.
How to change definition of day and night
As default the Memodayplanner shows the day from 7 am to 11
pm. The night is from 11 pm to 7 am. It is possible to change this
by using magnet strips that are sold as accessories.
Example: You want the day to start at 8 am and the night to begin
at 12 pm.
Cut the chosen magnet strip (with numbers or analogue
presentation of time) so that 8 am is placed over the number 7
on the Memodayplanner.
If presentation of time is of no value to the user you can put on
the blank magnet strips.
Do the same for the night.
Set the time one hour back compared to true present time (see
the chapter “How to set the time”).
