System and Error Messages 273
- the meter clock pulse changed and a new selflearning timeout has
been calculated anew.
ISDN-27: Incoming call from <Number> subaddress <x> rejected because the "Call
Status" is set to "Disabled".
indicates that the Call Status of this call destination is disabled and no
outgoing and incoming calls are allowed to and from this remote site.
ISDN-28: Incoming call from <Number> rejected because the budget is reached.
indicates that one of the budget values configured for this call desti-
nation was reached and the call destination was barred for outgoing
and incoming calls. Either set the budget value to (None) or enter a
higher value.
ISDN-29: Outgoing call to <Number> subaddress <x> rejected because the budget is
reached.
indicates that one of the budget values configured for this call desti-
nation was reached and the call destination was barred for outgoing
and incoming calls. Either set the budget value to (None) or enter a
higher value.
ISDN-30: Call to <Number> cleared because the budget is reached.
indicates that one of the budget values configured for this call desti-
nation was reached and the call was therefore cleared. No outgoing or
incoming calls are allowed to or from this call destination. To use this
destination again, either set the budget value to (None) or enter a
higher value.
ISDN-31: COSO changed to "No Dial-Out".
indicates that COSO changed to No Dial-Out either because config-
ured Time Restrictions came into effect or you set COSO to Remote
and the remote site did not reject your call on the D channel. As a
result, COSO changed to No Dial-Out.
ISDN-51: Outgoing call to <Number> subaddress <x> rejected because the local call
number components are not configured properly.
indicates that either no ISDN number or, if a PBX is used, no PBX
Extension has been configured. Enter the respective number in the
ISDN-Controller Interface Configuration.
Meldunge.pm6 27.05.97, 21:06273
