588475
11
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
2
en
HUMIDITY GAUGE
•DH 26
Positioned in the front of the appliance. It has a graduated scale
from 1 to 5. When the humidity gauge is set on the minimum
level (1), it means it will work until 80% of relative humidity is
obtained in the room. When it is set on the maximum level (5),
it means the appliance will work until 20% of relative humidity is
obtained in the room. When it is set on “CONT”, the appliance
works continuously no matter what the relative humidity level is.
When it is set on “OFF” the appliance will never start (single pole
switch) (Fig. 4).
•DH 44-62-92
Positioned on the front of the machine. It has a graduated
scale from a minimum of 80% to a maximum of 20% of relative
humidity to be obtained in the room (Fig. 5).
HOUR COUNTER
•DH 26
The hour counter is positioned on the rear of the machine and
indicates the number of hours the appliance has functioned (Fig.
6).
•DH 44-62-92
The hour counter is positioned on the front of the machine and
indicates the number of hours the appliance has functioned (Fig.
6).
FIRST IGNITION
IMPORTANT: In models with dual voltage (...DV), check
the position of the dual voltage switch (220-240V / 110-
120V). If the voltage set does not correspond to the mains
supplied voltage, it is necessary to adjust it. Unscrew the
two securing screws of the cover (Fig. 10), adjust/press
the switch to the correct voltage (Fig. 11) and reassemble
the cover (Fig. 12-13).
Before starting the appliance it must have been in an upright
position (the normal working position) for at least eight hours.
Failure to observe this instruction could cause irreparable
damage to the compressor.
After eight hours the dehumidier can be plugged into a 220-
240 Volt single-phase grounded socket. The “POWER” red
led must switched on to shows that is correctly powered. If
the “WORKING” led is off, turn the humidity gauge knob in a
clockwise direction until it comes on. The “DEFROST” led will
also come on and after about 5 minutes, the dehumidier starts.
If the green “FULL” led is on, the dehumidiers doesn’t start. The
tank must be emptied.
IF THE DEHUMIDIFIER DOES
NOT START OR DOES NOT
DEHUMIDIFY
First of all check the red “POWER” led is on. this shows that
it is correctly powered. Otherwise check if the plug is correctly
connected to the energy supply and if power reach the appliance.
If after these controls the light remains off, take the appliance to
the retailer where it was purchased.
Check the green “FULL” led is off and check the tank is empty.
Check the red “WORKING” led is on, this shows the humidity
gauge required to be in function. When the appliance starts after
a pause because the set humidity level has been reached or
because the tank has been emptied, the “DEFROST” led will
come on, besides the two “POWER” and “WORKING” leds.
They will remain on for about 3 minutes when only the fan will
be working and the compressor will be off.
This cycle is repeated about every 45 minutes to defrost the coil
(evaporator). If the “DEFROST” led remains on for more than
ten minutes take the dehumidier to the retailer where it was
purchased.
If the appliance seems to be working correctly with the
“WORKING” and “POWER” leds on, but no water or very few
is produced, check that the relative humidity in the room is
not lower than 40-45%, otherwise take the dehumidier to the
retailer where it was purchased.
CONNECTION TO A
DISCHARGE PIPE
•DH 26
This dehumidier can be connected directly to a xed discharge
pipe, in which case the tank is removed to enable connecting the
pipe to the coupling.
For the connection, insert the supplied coupling in the right
side of the tank compartment (Fig. 7). Use the supplied rubber
stopper to block the microswitch lever in the left side of the tank
compartment (Fig. 8).
•DH 44-62-92
This dehumidier can be connected directly to a xed discharge
pipe, in which case the tank is removed to enable connecting the
pipe to the threaded male coupling (Fig. 9) (for the model DH 92
remove the plastic connection pre-installed).
For the connection use a pipe with a ¾” female coupling.
PERIODIC MAINTENANCE
The only maintenance that is required is cleaning the lter, the
frequency depending on how dusty the room is and how many
hours the appliance actually works each day.
In normal use it is sufcient to clean the lter once a month, but if
the room is very dusty it should be cleaned more frequently.
The lter is cleaned by washing it under a jet of water in the sink,
owing in the opposite direction to the air ow: the perforated
front panel must face downwards so that the water pushes the
lter against the panel.
After a few years, the hot heat exchanger (condenser) could
need cleaning using compressed air and only a qualied
technician must do this task. This cleaning improves the
appliance efciency and guarantees its long life.
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw master DH 62 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van master DH 62 in de taal/talen: Alle talen als bijlage per email.

De handleiding is 7,67 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info