Parameter 1
Select the desired effect type for the DIST effect module
from the following seven types. Parameters 2 and 3 change
according to the selected effect type. Effect types 1–6
provide two variations (A/B) to produce different effects.
Type: 1A/1b CLEAN (clean)
Type: 2A/2b OVER DRIVE (over drive)
Type: 3A/3b DISTORTION (distortion)
Type: 4A/4b FUZZ/GRUNGE (fuzz/grunge)
Type: 5A/5b LEAD (lead)
Type: 6A/6b METAL (metal)
Type: 7 ACOUSTIC (acoustic)
■ Type: 1A/1b CLEAN (clean)
This effect type produces a clean sound.
1A (FAT CLEAN): Produces a firm sound with
emphasized mid and low ranges.
1b (BRIGHT CLEAN): Produces a bright sound with
an emphasized high range.
● Parameter 3: Tone
This parameter adjusts the tonal quality of the high range.
■ Type: 2A/2b OVERDRIVE (overdrive)
This is an overdrive effect.
2A (VINTAGE OD): Produces a sound with a vintage
amplifier flavor.
2b (OVERDRIVE): Produces a thick, solid sound with
plenty of sustain.
● Parameter 2: Gain
This parameter sets the amount of distortion.
● Parameter 3: Tone
This parameter adjusts the tonal quality in the high range.
■ Type: 3A/3b DISTORTION (distortion)
This is a distortion effect.
3A (VINTAGE DIST): Produces a dry distortion
sound.
3b (DISTORTION): Produces a wet distortion sound.
■ Type: 4A/4b FUZZ/GRUNGE (fuzz/grunge)
This fuzz effect produces a wild distortion.
4A (FUZZ):
Produces a 60’s retrospective fuzz tone.
4b (GRUNGE)
Produces a stimulating, contemporary fuzz sound.
● Parameter 2: Gain
● Parameter 3: Tone
■ Type: 5A/5b LEAD (lead)
This effect is suitable for a lead guitar.
5A (LEAD):
Sound with an edge in the mid range suitable for
lead guitar.
5b (VINTAGE LEAD):
Produces a solid, powerful sound with a vintage
amplifier flavor.
● Parameter 2: Gain
● Parameter 3: Tone
■ Type: 6A/6b METAL (metal)
This effect type is most suitable for a heavy metal sound.
16
DIST (distortion)
■ Type: 6/c6 SLOW ATTACK (slow attack)
This effect slows the attack of each tone to simulate a violin
technique. If you select “c6,” parameter 2 can be controlled
via RTM.
● Parameter 2: Rate (←RTM)
This parameter specifies the attack speed.
■ Parameters shared by effect types 1–6 and
c1–c6
● Parameter 3: POSITION (position)
This parameter specifies the order of the connection of the
COMP/WAH effect module and the DIST effect module.
1: The COMP/WAH effect module is followed by the
DIST effect module.
2: The DIST effect module is followed by the
COMP/WAH effect module.
● Parameter 4: Patch Level (P)
This patch parameter adjusts the overall volume of the
patch.
