T
rouble
shooting:
1. The mower does not
st
ar
t.
a) The mower starts in an ineffective fence line area. Check the fence line for repair.
b) Check the emergency stop switch. If the emergency stop switch is locked, press
the emergency stop switch then press red power switch.
c) If the mower has not been used for a long while, the battery may be empty. Make sure to
charge it again after charging. Even when unused, it is recommended that the battery is
charged every 3 months.
2. The mower does not move
forw
ard
.
a) The bumper might be stuck. Please turn off the mower and check the bumper. If the bumper
was broken or the sensor tube was sheltered by dirt, please use thing to clean it. if the
switch
is
returned to the start position after being pushed. If it can not
be back to position when push you
should remove possible objects or grass that has been stuck in the
bumper.
b) If the grass is
very long at the first time, which will shelter the sensor tube, please mow the grass with a
traditional lawn mower before using the robot mower.
3. The mower does not mow
properly
or at
a
ll.
a) Turn off the mower. Check if the blades are properly installed.
Replace the blades if damaged.
b) If the mower is in a slope which has an angle more than 45
o
, the mower will automatically
stop.
c). The root part of the blade holder is stuck by objects or grass. Remove them and restart.
d) The grass is too dense to be mowed due to the automatic protection of machine.
4. The mower crosses the fence line and
continues
outside the
p
erime
ter
.
a)The fence line turn angle is too steep. The inner angle must be at least 125
o
.
b) The fence line is too close to a slope. Adjust the fence line position to be in
accordance to the recommendations.
C) The fence line signal is weak. The fence line must not exceed 200m.
5. The battery is not
c
har
ging.
a) The extruding poles of the charger are not in contact with the paddles of the charging station.
b) The extruding poles or the paddles are dirty. Clean them. (Make sure to
disconnect the power before cleaning.)
c) If long time no charge, the left power will be exhausted by itself. If the battery
broken a little you can re-charge many times to active the battery or you can
change the battery
.
