481442
7
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
+ +
+
2
Push in the ignition button C (Fig. L), but do not apply too much force.
Release the ignition button as soon as a flame is visible in the combustion
chamber D.
If the heater has been used only a few times and the wick adjustment knob is not
locked, first turn the wick adjustment knob (Fig. M) completely left, before putting
the wick in the highest position for ignition (Section C).
After having ignited the heater, always check whether the combustion
chamber D is level, by sliding it slightly to the left and the right by its handle E
(Fig. E). This should be a smooth movement. If the combustion chamber is not
level, this will cause smoke and soot to develop.
D BURNING OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can check
whether the heater is burning well. Too high a flame may cause smoke and soot,
whereas too low a flame causes smells. The page opposite the folding page shows
the minimum and maximum permissible burning heights of the flame (Fig. Q). The
flame can be slightly adjusted with the knurled wick adjustment knob B (Fig. M).
Burning that is too low may be caused by:
E insufficient fuel (fill the tank)
E poor fuel quality (contact your dealer)
E insufficient ventilation (put window or door ajar)
E wastage of the wick (contact your dealer or replace the wick,
refer to section L)
E SWITCHING OFF THE HEATER
Let the heater burn at its lowest setting (Fig. M) for approximately one minute.
Then slowly turn the knurled wick adjustment knob B anti-clockwise to its stop.
The flame will extinguish after a little while.
In case of an emergency, switch off the heater by pushing in the safety button
A (Fig. N).
F MALFUNCTION, CAUSES AND SOLUTIONS
If any malfunctioning cannot be solved from the directions below, please contact
your dealer.
THE HEATER DOES NOT IGNITE
E The batteries are not positioned correctly in the holder.
Check (Fig. F).
E There is not enough power left in the batteries for the ignition.
Replace (Fig. F).
E You have run out of fuel from the tank or the wick has been replaced.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
E You are pushing the ignition button C with too much force.
Push it in less forcefully (Section C).
E The ignition coil K is defective.
Contact your dealer.
4
43
L
M
N
F
E
7

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Zibro-R-26T

Zoeken resetten

  • ik heb een Zibro R 26 T, tot groot genoegen. helaas blijkt hij niet te kunnen temperen, ik bedoel dus lager branden, alleen een heel klein beetje als ik de zwarte knop naar links draai. dit kan maar een heel klein stukje. in de gebruiksaanwijzing vind ik hierover niets. kunt u me helpen? Gesteld op 5-11-2020 om 11:52

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zibro R 26T bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zibro R 26T in de taal/talen: Engels als bijlage per email.

De handleiding is 1,13 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Zibro R 26T

Zibro R 26T Gebruiksaanwijzing - Nederlands - 16 pagina's

Zibro R 26T Gebruiksaanwijzing - Deutsch - 16 pagina's

Zibro R 26T Gebruiksaanwijzing - Français - 16 pagina's

Zibro R 26T Gebruiksaanwijzing - Italiano - 16 pagina's

Zibro R 26T Gebruiksaanwijzing - Espanõl - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info