460314
7
Verklein
Vergroot
Pagina terug
1/14
Pagina verder
B FILLING FUEL
Fill the removable tank in a suitable place since there can always be some spillage.
Follow the procedure below:
Make sure that the heater is switched off.
Open the upper lid and lift the removable tank out of the heater (Fig. B).
Note: Some drops may leak from the tank. Put down the removable tank (cap
pointing upwards, handle on floor (Fig. C) and screw off the fuel cap.
Fill the removable tank using a fuel pump (refer to fuel pump operation
instructions.) Make sure that it is in a higher position than the removable tank
(Fig. D). Insert the ribbed hose into the opening of the removable tank.
Check the removable tank fuel gauge while filling the tank (Fig. E). Stop fill-
ing once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
Let the remaining fuel in the pump flow back into the jerry can and carefully
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C SETTING THE CLOCK
It is only possible to set the correct time, when the heater is connected to the
mains and not burning. Use the adjustment keys ƺ to set the time. First press
either of the two keys to switch on the function (the 4-digit ¹ will start blinking).
Next, set the hours using the key (Ĭhour) and the minutes using the key (įmin.).
Press once to increase the value by one step. When you hold down the key, the
value will continue going up, until you release the key again. After approximately
10 seconds the 4-digit will stop blinking and the setting will be locked. 5 minutes
after switching off the heater, the information on the display will disappear and
the heater will automatically switch into the stand-by position.
When the heater has been unplugged for more than 10 minutes (or after a
power failure), the time needs to be set again.
D IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the button
Ƹ
. Never use matches or a cigarette
lighter.
Just press the button Ƹ to ignite the heater.
The button will start blinking, indicating that the ignition procedure has started.
This will take a short while. Once the heater is burning, the button Ƹ will
remain lit (red). The information display ¹ will show two numbers (Fig. G). The
actual room temperature is indicated below ROOM, while the temperature setting
is indicated below SET. The latter can be changed with the adjustment keys (refer
to Section E).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
1
2
3
4
5
6
4
56
F: When the 4-digit stops
blinking, the setting has
been locked to the
indicated value.
D
C
B
E
empty full
man_SRE237E_uk.qxd:uk 24-05-11 15:56 Page 56
7

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Zibro-Kamin-SRE237E

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zibro Kamin SRE237E bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zibro Kamin SRE237E in de taal/talen: Engels als bijlage per email.

De handleiding is 0,72 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Zibro Kamin SRE237E

Zibro Kamin SRE237E Gebruiksaanwijzing - Nederlands - 10 pagina's

Zibro Kamin SRE237E Gebruiksaanwijzing - Français - 28 pagina's

Zibro Kamin SRE237E Gebruiksaanwijzing - Italiano - 13 pagina's

Zibro Kamin SRE237E Gebruiksaanwijzing - Dansk - 15 pagina's

Zibro Kamin SRE237E Gebruiksaanwijzing - Svenska - 14 pagina's

Zibro Kamin SRE237E Gebruiksaanwijzing - Alle talen - 127 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info