38
In case of no room for ice tray ice cubes can be made
and/or stored on top of ice-making compartment.
For purchasing further ice trays contact your local dealer.
Ready ice cubes can be taken out of the tray under
running water then twist or hit it.
Some useful information and advice
The shelf inside the appliance has a back-folding
part on the left side that makes storing large-sized
bottles possible.
Top doorshelves taken out of the appliance can be used
for serving foods (fruit, salads, etc.).
Two doorshelves put together can be used for storing
foods in or outside the appliance (e.g. on excursions).
Hints and ideas
In this chapter practical hints and ideas are given about
how to use the appliance to reach maximum energy
saving and there is environmental information about the
appliance as well.
How to save energy
Avoid putting the appliance in a sunny place and near
anything that gives off heat.
Be sure that the condenser and the compressor are
well ventilated. Do not cover the sections where
ventilation is.
Wrap products in tightly closing dishes or cling film to
avoid building up unnecessary frost.
Do not leave the door open longer than necessary
and open it when it is needed.
Put liquid into the appliance only in a closed dish.
Put warm foods and liquid in the appliance only when
they are at room temperature.
Defrost the appliance when the ice in the ice-
making compartment is more than 4 - 5 mm
thick.
Keep the condenser clean.
The appliance and environment
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant circuit or
insulation materials. The appliance shall not be discarded
together with the urban refuse and rubbish. Avoid
damaging the cooling unit, especially at the rear near the
heat exchanger. Information on your local disposal sites
may be obtained from your municipal authorities.
The materials used on this appliance marked with the
sympol are recyclable.
Maintenance
Leolvasz tás
Defrosting
Bleeding part of the moisture of cooling chamber in form
of frost and ice goes with the operation of the refrigerator.
Thick frost and ice has an insulating effect, so it reduces
cooling efficiency as the temperature increases, it needs
more energy, at a certain thickness it does not allow the
door of the ice-making compartment to open, possibly
the door can be broken.
We recommend to defrost the ice-making
compartment once a week and when the frost
is more than 4-5 mm.
How to defrost it:
Break the circuit of the appliance or turn thermostatic
control knob into „0” position.
Empty the ice box. Wrap foods inside into newspaper
and put them on a cool place or into another appliance.
Leave the door of the appliance and ice-making
compartment open.
Defrosting usually takes several hours. When finished,
pour defrost water gathered out of the tray and wipe the
surfaces dry.
Apply voltage to the appliance or turn thermostatic
control knob to middle („4”) position.
Put foods taken out back to their places.
Regular cleaning
It is recommended to wash the inside of the refrigerator
in 3-4 weeks time.
Household cleaner or soap must not be used.
After you made it no-current wash the appliance using
lukewarm water and wipe it.
Clean the magnet door rubber profile with clean water.
After cleaning plug the appliance to the mains socket.
It is practical to clean and defrost the ice-making
compartment at a time and when it is empty.
Dust and dirt collected on the back of the refrigerator,
condenser is recommended to be removed once or
twice a year.
When the refrigerator is not in use
In case the appliance will not be used for a long time
follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-current.
That is why you must not touch the electrical parts of the
appliance before breaking the circuit.
GGBB
