37
Operating sequence
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
as much as possible. Close the door.
2. Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked .
If required, pour fabric softener into the
compartment marked (the amount used must
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
3. Select the required programme
The selector dial is
divided into following
sections:
● Cottons,
● Synthetics,
● Special
The green Start/Pause light starts to flash.
The selector dial can be turned either
clockwise or anticlockwise.
Position «Off» to Reset programme/Switching
OFF of the machine.
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to another
programme when the machine is working, the
red Start/Pause pilot light will flash 3 times to
indicate a wrong selection. The machine will not
perform the new selected programme.
4. Select the spin speed or Rinse Hold
option
Press the Spin button repeatedly to change the
spin speed, if you want your laundry to be spun
at a speed different from the one proposed by
the appliance.
The relevant light will light up.
Maximum speeds are:
Delicates, Wool and
Handwash: 450 rpm
Rinse Hold : by selecting this option the
water of the last rinse is not emptied out to
prevent the fabrics from creasing. When the
programme has finished the pilot lights «Door»
and «End» are alight, the Start/Pause and
«Wash» lights are off and the door is locked to
indicate that the water must be emptied out.
Night Cycle :The water of the spin's end
can't be evacuated at the end of selected
program to avoid the creases on laundry.
In all phases of spin, the sound has been
removed and the appliance can be used during
night. Over Cotton and Synthetics programs,
rinses are made with more water.
To empty out the water:
1.turn the programme selector dial to «Off»
2.select the Drain or Spin programme
3.reduce the spin speed if needed, by means of
the relevant button
4.depress Start/Pause button
5. at the end of programme, only the pilot lights
End comes on.
