48
Changing the opening direction of
the doors
Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out door reversal operate as follows:
1. dismantle the lower hinge (1), and the support
foot (2);
2. unscrew the left front foot (3) and reposition on
the opposite side;
3. Slide out the lower door from middle hinge (H)
and remove the latter;
4. Slide out the upper door from pin (G), unscrew
the latter and then screw it down into the hinge
provided on the opposite side;
5. Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other
side;
6. Refit the upper door and the middle hinge on the
opposite side;
7. Refit the lower door;
8. reassemble the lower hinge (1), and the support
foot (2) on the opposite side;
Important
For the alignement of the doors, adjust the middle
hinge horizontally, after having loosened the two
screws.
Attention
After completion of the door reversibility
operation, verify that the door gasket is adherent
to the cabinet. If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
Rear spacers
The plastic bag containing all relevant
documentation also contains two spacers to be fitted
into special holes in the back of the appliance. Fit
the spacers into the holes, taking care to ensure that
the arrow (A) is positioned as shown in Figure. Then
turn them through 45° (arrow (A) vertical) until they
lock into place.