39
Change of door opening direction
Should the setting-up place or handling demand it, door-
opening direction can be refitted from right-handed to left-
handed.
Following operations are to be done on the basis of fig-
ures and explanations:
Pull out the plug from the mains socket.
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5-1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal dis-
tances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
Then screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces) and set up the box.
For refitting the upper door holder take out the screws
(2 pieces) fixing the plastic top on the back of the box.
Push back the top and lift it from the fixing elements.
Unscrew the screws fixing the upper door holder (2
pieces).
After unscrewing turn over the pin in the door holder
plate in the direction of the arrow.
Fit and fix the door holder plate on the other side with-
out displacing the door.
Put back the plastic top on the fixing elements and pull
it forward.
Fix the top with the screws (2 pieces) on the back side
of the box.
Put over the handle and the plastic nails on the other
side.
Put the appliance to its place, set it level and plug it
into the mains socket.
In case you do not want to perform the procedures above,
call the nearest brand-mark service. Technicians will
accomplish the refitting expertly for charge.
GB
Tilt back the appliance carefully being careful so that
the compressor can not touch the floor. It is recom-
mended to ask another person for help, who can keep
the appliance at this position safely.
Unscrew the adjustable feet situated on both sides (2
pieces), in addition the screws fixing the lower door
holders (2 pieces) respectively the screw on the other
side.
Put over the pin in the lower door holding plate in the
direction of the arrow.
Fix the plate on the other side leaving the position of
the door unchanged.
