101193
17
Verklein
Vergroot
Pagina terug
1/64
Pagina verder
GB 17
Extraction
The cooker hood is more effective when used in the extraction mode (ducted to the outside).
Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent
of Ø125mm (5”) or Ø150mm (6”).
For the best performance use the shortest possible duct run and the minimum number of bends.
Where exible ducting is tted it should not be turned through very tight bends as this may impair the perform-
ance of the hood.
It is recommended a maximum length of 3 metres with one bend, to be installed, to be reduced metre for each
90o bend.
If a distance is greater than 3 metres the ef ciency of the hood could be impaired.
The ducting used must be manufactured from re retardent material conforming to the relevant British Standard
or DIN 4102-B1.
When the cooker hood is ducted to the outside the charcoal lter must be removed.
INSTALLING THE COOKER HOOD
Installation of components in recycling version:
Fix the recycling air outlet piece 15 to the upper part
of the frame using four 12c screws supplied with the
hood.
• Fix the ange (ø120) 10 to the lower part of the recycling
air outlet 15.
• Put the reducer ange 9 on the hood body outlet.
At this point, join the anges with a pipe. In order to
calculate the height of the pipe it is necessary to estimate
the height of the hood (mm) and subtract 615 mm. (H
pipe = H hood-615).
Lengthen the frame so that the pipe can be inserted.
Place the pipe between the two anges and block it. Make
sure that the height of the frame is correct considering
the height of the cooker hood (H frame = H hood – 184).
Adjust the height of the frame and tighten again the earlier
removed screws. Tighten again the safety screws in order
to give more stability to the structure.
Fix the pipe with the pipe clamps 25 supplied with the
hood.
Lift the frame up, making sure that the index over the
frame plate is turned backwards.
Fit the frame slots onto the two screws inserted in the
ceiling as above, and turn until reaching the centre of
the adjustment slot.
Tighten the two screws and fasten the other two screws
provided; before locking the screws completely, it is
possible to adjust the frame by turning it, making sure
that the screws do not come out of their housing in the
adjustment slot.
15
12c
10
2
1
1
The Frame must be securely fastened so as to support both the weight of the Hood and the stress
caused by occasional axial pressure against the tted Appliance. After xing, make sure that the base
is stable even when the Frame is subjected to lateral stress.
If the Ceiling is not strong enough in the area where the hood is to be xed, the Installer must strengthen
the area using suitable plates and counterplates anchored to resistant structures.
17

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Zanussi-ZHC-590

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zanussi ZHC 590 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zanussi ZHC 590 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 2,47 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info