4
3.1- Installation of the fitted group
1 - Make a rectangular opening in the base of the overhead cupboard or hood, leaving a minimum
of 13 mm from the outer edges according to the dimensions indicated in the table.
2 - Drill a hole into the upper side of the cabinet in accordance with the dimensions of the duct used
for both the evacuation and recirculation mode.
3 - Dismantle the ducting support (version with grill or version with filters), pulling the two pommels
A (fig. 1) simultaneously:
a)Fixing frame with screws:
Fix the fitted group to the hood or cupboard, using the self-threading screws (No. 8) provided
with the accessories (fig. 2).
b)Rapid fixing with side supports:
The device B is set up to deal with a panel thickness of from 15 mm to 30 mm. Insert the
group into the opening until the two devices B connect. Lock the adjustment screw C until the
fitted group adheres tightly to the surface (fig. 2).
4 - Close the ducting support by pushing and connecting the two pommels A (fig. 3).
3.2- Ducting or recirculation fitting
1 - Ducting fitting:
a)The hood can be ducted to the outside using either a rigid or a flexible Ø 100 or 120 mm
duct to be fixed with suitable clamps, not provided (fig. 2).
b)If the hood is provided with the charcoal filters fitted, the filters should be removed
(see par.3.2 part 2).
2 - Recirculation fitting:
a)When used in the recirculation mode, the charcoal filters must be fitted into the cooker hood
(see par. 3.2 part 2).
b)The air is recirculated into the kitchen through the opening located on the upper side of the
cabinet or of the hood (fig. 3).
3.3- Electrical connection and working test
1 - The safety measures 2.2, 2.3 and 2.4 of paragraph 2 are to be strictly observed.
2 - Once the electrical connection has been completed, check that the worktop illumination, motor
and speeds work properly.
Part 2 - USE AND MAINTENANCE
INSTRUCTIONS
1 - SAFETY WARNINGS
It is most important that all the warnings shown in paragraph 2 of the Installation
Instructions are strictly observed.
Moreover, special attention must be paid to the following warnings during the use and
maintenance of the cooker hood:
1.1 - The grease filters and the charcoal filters should be cleaned or replaced as recommended
by the manufacturer or more frequently if the hood is used consistently (more than 4 hours
per day).
1.2 - When using a gas hob in connection with the cooker hood never leave the burners of the
hob uncovered while the hood is in use or when the pans have been removed. Switch off
the gas before removing the pan or for just short periods and never leave the hob unattended.
1.3 - Always ensure that the appliance is kept at the correct intensity to prevent the flame from
