7
Filling with rinse aid
(Rinse aid dispenser type B)
1. Open the container by turning the lid (A) anticlockwise.
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
Ensure that the lid is closed after every refill.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (C)
(position 1 minimum dosage, position 6 maximum dosage).
Increase the dose if there are drops of water or lime spots on
the dishes after washing.
The dose is factory set in
position 5.
Reduce it if there are sticky
whitish streaks on the
dishes.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Top up the rinse aid when the rinse aid indicator light on the
control panel illuminates.
It is possible to deactivate the rinse aid indicator light (see
following instructions).
To deactivate the rinse aid indicator
light proceed as follows:
(The dishwasher must be switched off)
1. Press function push buttons 1 and 2 simultaneously.
2. While keeping the function push buttons 1 and 2 pressed
switch on the dishwasher by pressing the On/Off push
button.
The On/Off indicator light comes on.
At the same time, the indicator lights of function push
buttons 1 and 2 start flashing.
3. Press function push button 2, the corresponding indicator
light keeps flashing while the indicator light of function push
button 1 turns off. At the same time the rinse aid indicator
light starts to flash.
4. Press function push button 2 again, the rinse aid indicator
light turns off, this means that the rinse aid indicator light
has been deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off push button.
To reactivate the rinse aid indicator light follow the same
process until the rinse aid indicator light starts to flash.
