528942
22
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
Turn off the water tap.
Unscrew the hose
from the tap.
Clean the filter in the
hose with a stiff brush.
Screw the hose back onto the tap. Make sure the
connection is tight.
Unscrew the hose from the machine. Keep a rag
nearby because some water may flow.
Clean the filter in the valve with a stiff brush or
with the piece of cloth.
35°
45°
Screw the hose back to the machine and make
sure the connection is tight.
Turn on the water tap.
Frost precautions
If the machine is installed in a place where the temper-
ature could drop below 0°C, remove the remaining wa-
ter from the inlet hose and the drain pump.
1. disconnect the mains plug from the mains socket.
2. close the water tap
3. unscrew the water inlet hose from the tap;
4. put the two ends of the inlet hose in a container
and let the water flow out of the hose.
5. empty the drain pump as described in the ‘Emer-
gency emptying out’ section.
6. when the drain pump is empty, install the water in-
let hose again.
Warning!
Make sure that the temperature is more than 0 °C be-
fore you use the appliance again.
The manufacturer is not responsible for damages
caused by low temperatures.
Emergency emptying out
If the appliance cannot drain the water, proceed as fol-
lows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has cooled down;
4. open the pump door;
5. place a container on the floor below the recess of
the drain pump;
6. press the two levers and pull forward the drainage
duct to let the water flow out;
7. when the container is full of water, put the drain-
age duct back again and empty the container;
repeat this operation until water stops flowing out;
8. if necessary clean the pump (refer to the section
‘Cleaning the pump’ );
9. close the drain pump door.
When you drain the water with the emergency drain
procedure, you must activate again the drain system:
1. Put 2 litres of water in the main wash compart-
ment of the detergent dispenser.
2. Start the programme to drain the water.
What to do if ...
Certain problems are due to lack of simple mainte-
nance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local
Service Centre, please carry out the checks listed be-
low.
During machine operation it is possible that the red pi-
lot light of button 7 blinks, one of the following alarm co-
des appears on the display and some acoustic signals
sound every 20 seconds to indicate that the machine is
not working:
22
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zanker WTF968A.8 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zanker WTF968A.8 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,16 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Zanker WTF968A.8

Zanker WTF968A.8 Gebruiksaanwijzing - Deutsch - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info