NOTICES AND WARNINGS
OVERVIEW
TYPHOON Q500+ Quickstart V3.0
IMPORTANT NOTE: All safety precauons and warnings, instrucons, warranes and other collateral informaon is subject to
change at the sole discreon of Yuneec. For the most up-to-date informaon please visit the corresponding product page at
www.Yuneec.com or contact the nearest Yuneec office or authorized distributor.
The following special language terms are used throughout the product literature to indicate various levels of potenal harm
when operang this product:
NOTICE: Procedures, which if not properly followed, create a possibility of property damage and/or lile to no possibility of injury.
CAUTION: Procedures, which if not properly followed, create the probability of property damage and/or a possibility of serious injury.
WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage and/or
serious injury or create a high probability of superficial injury.
WARNING: Read the ENTIRE quick start guide and instrucon manual to become familiar with the features of the product
before operang. Failure to operate the product correctly can result in damage to the product, property and/or cause serious injury.
WARNING: This is a sophiscated consumer product. It must be operated with cauon and common sense, and requires some
basic mechanical ability. Failure to operate this product in a safe and responsible manner could result in damage to the product,
property and/or cause serious injury. This product is not intended for use by children without direct adult supervision. Do not
use with incompable components or alter this product in any way outside of the instrucons provided by Yuneec. The quick
start guide and instrucon manual contain instrucons for safety, operaon and maintenance. It is essenal to read and follow
all the instrucons and warnings prior to assembly, setup and/or use in order to operate the product correctly and avoid damage
or serious injury.
AGE RECOMMENDATION: NOT FOR CHILDREN UNDER 14 YEARS. THIS IS NOT A TOY.
GENERAL SAFETY PRECAUTIONS AND WARNINGS
WARNING: Failure to use this product in the intended manner as described in the quick start guide and instrucon manual can
result in damage to the product, property and/or cause serious injury. A Radio Controlled (RC) mulrotor aircra, APV plaorm,
drone, etc. is not a toy! If misused it can cause serious bodily harm and damage to property.
WARNING: As the user of this product you are solely and wholly responsible for operang it in a manner that does not endanger
yourself and others or result in damage to the product or the property of others.
Keep your hands, face and other parts of your body away from the spinning propellers/rotor blades and other moving parts at
all mes. Keep items that could impact or become entangled away from the propellers/rotor blades including debris, parts, tools,
loose clothing, etc.
Always operate your aircra in open areas that are free from people, vehicles and other obstrucons. Never fly near or above
crowds, airports or buildings.
To ensure proper operaon and safe flight performance never aempt to operate your aircra nearby buildings or other
obstrucons that do not offer a clear view of the sky and can restrict GPS recepon.
Do not aempt to operate your aircra in areas with potenal magnec and/or radio interference including areas nearby
broadcast towers, power transmission staons, high voltage power lines, etc.
Always keep a safe distance in all direcons around your aircra to avoid collisions and/or injury. This aircra is controlled by a
radio signal subject to interference from many sources outside your control. Interference can cause momentary loss of control.
To ensure proper and safe operaon of the automac landing funcon in Home Mode you must start the motors with the aircra
in a posion that has at least 10 feet (approximately 3 meters) of clear and open space around it and achieve a proper GPS lock.
Do not aempt to operate your aircra with any worn and/or damaged components, parts, etc. (including, but not limited to,
damaged propellers/rotor blades, old baeries, etc.).
Never operate your aircra in poor or severe weather condions including heavy winds, precipitaon, lightning, etc.
Always operate your aircra starng with a fully charged baery. Always land as soon as possible aer the first level low voltage
baery warning or land immediately aer the second level low voltage baery warning (as indicated by the vibraons and
audible alerts from the transmier/personal ground staon).
Always operate your aircra when the voltage of the baery in the transmier/personal ground staon is in a safe range (as
indicated by the baery charge status icon on the screen of the transmier/personal ground staon).
Always keep the aircra in clear line of sight and under control, and keep the transmier/personal ground staon powered on
while the aircra is powered on.
Always move the throle control sck down fully and turn off the motors in the event the propellers/rotor blades come into
contact with any objects.
Always allow components and parts to cool aer use before touching them and flying again.
Always remove baeries aer use and store/transport them per the corresponding guidelines.
Avoid water exposure to all electronic components, parts, etc. not specifically designed and protected for use in water. Moisture
causes damage to electronic components and parts.
Never place any poron of the aircra or any related accessories, components or parts in your mouth as doing so could cause
serious injury or even death.
Always keep chemicals, small parts and electronic components out of the reach of children.
Carefully follow the instrucons and warnings included with this aircra and any related accessories, components or parts
(including, but not limited to, chargers, rechargeable baeries, etc.).
CAUTION: The electronic speed controls (ESCs) installed in TYPHOON are not compable with any other product, and
TYPHOON is not compable with any other ESCs. Use of any other ESCs in TYPHOON will cause a crash, which may result in
damage to the product, property and/or cause serious injury.
BATTERY WARNINGS AND USAGE GUIDELINES
WARNING: Lithium Polymer (LiPo) baeries are significantly more volale than alkaline, NiCd or NiMH baeries. All instrucons
and warnings must be followed exactly to prevent property damage and/or serious injury as the mishandling of LiPo baeries
can result in fire. By handling, charging or using the included LiPo baery you assume all risks associated with LiPo baeries. If
you do not agree with these condions please return the complete product in new, unused condion to the place of purchase immediately.
You must always charge the LiPo baery in a safe, well-venlated area away from flammable materials.
Never charge the LiPo baery unaended at any me. When charging the baery you must always remain in constant observaon
to monitor the charging process and react immediately to any potenal problems that may occur.
Aer flying/discharging the LiPo baery you must allow it to cool to ambient/room temperature before recharging.
To charge the LiPo baery you must use only the included charger or a suitably compable LiPo baery charger. Failure to do so may
result in a fire causing property damage and/or serious injury.
If at any me the LiPo baery begins to balloon or swell, disconnue charging or discharging immediately. Quickly and safely
disconnect the baery, then place it in a safe, open area away from flammable materials to observe it for at least 15 minutes.
Connuing to charge or discharge a baery that has begun to balloon or swell can result in a fire. A baery that has ballooned or
swollen even a small amount must be removed from service completely.
Do not over-discharge the LiPo baery. Discharging the baery too low can cause damage to the baery resulng in reduced power,
flight duraon or failure of the baery enrely. LiPo cells should not be discharged to below 3.0V each under load.
Store the LiPo baery at room temperature and in a dry area for best results.
When charging, transporng or temporarily storing the LiPo baery the temperature range should be from approximately 40–120°
F (5–49° C). Do not store the baery or aircra in a hot garage, car or direct sunlight. If stored in a hot garage or car the baery can
be damaged or even catch fire.
Never leave baeries, chargers and power supplies unaended during use.
Never aempt to charge low voltage, ballooned/swollen, damaged or wet baeries.
Never allow children under 14 years of age to charge baeries.
Never charge a baery if any of the wire leads have been damaged or shorted.
Never aempt to disassemble the baery, charger or power supply.
Never drop baeries, chargers or power supplies.
Always inspect the baery, charger and power supply before charging.
Always ensure correct polarity before connecng baeries, chargers and power supplies.
Always disconnect the baery aer charging.
Always terminate all processes if the baery, charger or power supply malfuncons.
FCC STATEMENT:
This equipmen t has been tested and found to comply with the limits for P art 15 of the FCC rules. These limits ar e designed to provide
reasonable pro tecon against harmful interfer ence in a residen al installaon. This equipment generates, uses and can r adiate radio
frequency energy and, if not installed and used in acc ordance with the instrucons, may cause harmful interference to radio
communicaons.
Howev er, there is no guarantee that interfer ence will not occur in a parcular installaon. If this equipment does cause harmful
interferenc e to radio or television recepon, which can be determined by turning the equipment off and on, the user is encouraged
to try to corr ect the interferenc e by one or more of the f ollowing measures:
Reorient or relocate the rec eiving antenna.
Increase the separaon betw een the equipment and receiver .
Connect the equipment to an outlet on a circuit diff erent from tha t to which the receiv er is connected.
This device complies with part 15 of the FCC rules. O peraon is subject to the following two c ondions:
(1) This device ma y not cause harmful interfer ence, and (2) this device must accept any interfer ence received, including interf erence
that may cause undesir ed operaon.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This
equipment generates, uses and can radiate r adio frequency energy and, if not installed and used in acc ordance with the instrucons,
may cause harmful interferenc e to radio communicaons. However , there is no guarantee that interference will not occur in a
parcular installa on. If this equipment does cause harm ful interfer ence to radio or television r ecepon, which can be determined by
turning the equipment off and on, the user is encouraged to try to c orrect the interfer ence by one or more of the following measur es:
—Reorient or relocate the rec eiving antenna.
—Increase the separaon betw een the equipment and receiver .
—Connect the equipment into an outlet on a circuit diff erent fr om that to which the rec eiver is connected.
—Consult the dealer or an e xperienced radio/TV technician for help.
RF EXPOSURE W ARNING
This equipment must be installed and operated in accordance with pr ovided instrucons and the antenna(s) used for this transmier
must be installed to pro vide a separaon distance of at least 20 cm from all persons and must not be co-located or operang in
conjuncon with any other antenna or transmier. End-users and installers must be provide with antenna installaon instrucons
and transmier operang c ondions for sasfying RF exposure compliance.
IC RADIA TION EXPOSURE ST A TEMENT FOR CANADA
This device complies with Industry Canada licence-e xempt RSS standard(s ).
Operaon is subject to the following two condions: (1) this device may not cause interfer ence, and (2) this device must accept any
interferenc e, including interfer ence that may cause undesired operaon of the de vice.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L ' exploitaon est
autorisée aux deux c ondions suivantes : (1) l'appareil ne doit pas pr oduire de brouillage, et (2) l'ulisateur de l'appar eil doit accept er
tout brouillage radioélectrique subi, même si le br ouillage est suscepble d'en c ompromere le f onconnement.
This equipment complies with IC RSS-102 radia on exposure limit set forth f or an uncontr olled environment.
Cet équipement respecte les limites d' exposion aux rayonnemen ts IC définies pour un environnemen t non contrôlé
1 CGO2+ Gimbal Camera
2 Camera Microphone
3 Camera LED Status Indicator
4 Camera Lens
5 5.8GHz Antenna
6 Main LED Status Indicator
7 Power Switch
8 Proporonal Control Rate Slider
9 USB Connector/Charging Port
10 Audio/Earphone Jack
11 Take Sll Photo Buon
12 Start/Stop Motors Buon
13 Rudder/Yaw Control (for Mode 2 and Mode 1)
14 Throle/Altude Control (for Mode 2)
Elevator/Pitch Control (for Mode 1)
15 5.8GHz Antenna (located inside the case)
16 Status Indicators (for ST10+ baery, 5.8GHz
WiFi and GPS)
17 2.4GHz Antenna (located inside the handle)
18 Start/Stop Video Recording Buon
19 Flight Mode Selecon Switch
20 Aileron/Roll Control (Mode 2 and Mode 1)
21 Elevator/Pitch Control (Mode 2)
Throle/Altude Control (Mode 1)
22 Power Switch
23 Volume and Navigaon Touch-Acvated
Buons Volume Down/VolumeUp/Menu/Home/Back)
24 CGO2+ Pitch Angle/Posion Control
Slider
25 SD Card Slot (located under the baery)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15 16 17
18
19
20
21
22
23
24
25