633004
10
Verklein
Vergroot
Pagina terug
1/29
Pagina verder
8
BINDING H920 MULTICOPTER TO THE ST12 (TEAM MODE)
STEP 1: Power on the ST12 and tap “RC” on the main interface
STEP 2: Tap Model Select and if required press “OK” to bypass any pop up warning/alerts.
STEP 3: Tap to create a new model and if required press “OK” to bypass any pop up
warnings/alerts.
STEP 4: Tap Flight Settings and if required press “OK” to bypass any pop up warnings/alerts.
STEP 5: Lift the H920 back end upward approximately 45° , then back down to “level” twice
till the main LED indicator blinks yellow.
STEP 6: Tap the Refresh icon. Select the code of the H920 listed in the column under ”Model”
and tap Bind ,then tap “OK” after the connection has been established
STEP 7: When tapping, you will hear two long beeps from the aircraft. That means the ST12
is bound to the H920 successfully.
CAMERA CONTROL ON MULTICOPTER (TEAM MODE)
GIMBAL PITCH CONTROL
There is a gimbal pitch mode switch on ST24---S1. When the switch is in up/middle position,
the gimbal camera is in Angle Mode. Use K5 to set the pitch/tilt position of the gimbal
camera. When the S1 is in bottom position, the gimbal camera
is in Velocity Mode. When the right-hand stick is in the middle
position, it means the velocity rate is 0 for the CGO4, and it
will stop pitching up/down. When the right-hand stick is above
the middle position, the CGO4 will start pitching up. When the
right-hand stick is below the middle position, the CGO4 will
start pitching down. The distance between the right-hand stick
and the middle position decides the velocity rate, the further
distance, the higher velocity it would be.
GIMBAL YAW CONTROL
There is a gimbal yaw mode switch on ST24---S2. When the switch position is up, the gimbal
camera is in Follow Mode. The yaw control of the gimbal camera is now disabled; when the
switch is in the middle position, the gimbal camera is still in Follow Mode, however, at this
time, the yaw control is activated. The gimbal camera will adjust its yaw direction according
to the aircraft’s movements. When the switch position is down, the gimbal camera is in Global
Mode. The Aileron/Roll Control and Elevator/Pitch Control of the right-hand stick take
control of the CGO4 in yaw and pitch directions.
STEP 8:
Tap [ ] twice to return to the main screen and the model /receiver should automati-
cally connect to ST12
NOTICE: The H920 main LED indicator will blink red and white if the TORNADO loses GPS
signal /lock. The H920 main LED indicator will be solid color of the current mode if the GPS
signal/lock is acquired.
S2
Zoom CGO4
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yuneec Tornado CGO4 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yuneec Tornado CGO4 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,43 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Yuneec Tornado CGO4

Yuneec Tornado CGO4 Snelstart handleiding - English - 13 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info